Hello.
Got a Duos 2 to try to revive but no luck so far.
Status:
Power on and stuck at Samsung logo
First time i managed to enter in recovery and did a wipe (data,cache) in the process got a data partition corruption error in red.
Download mode is working, tried to apply a stock firmware via Odin, no errors but still stuck on logo.
After that i can't enter in recovery mode anymore, tried a few custom recoverys applied via odin, but again no recovery mode.
Any ideas?
I only got download mode and no recovery.
affter odin. go to stock recovery wipe facrory reset
Flash the repair frimware to ur device using odin. This will definitely fix the problem.
Download link- https://www.androidfilehost.com/?fid=24499762636002990
Note- repair frimware always comes in Arabic language but you can change the language at the setup screen.
1-install twrp and do clean flash with formating internal storage
2-flash stock you of your region with odin and remember after flashing complete and odin says pass than remove the cable do not remove when it says reset.....
3-if phone stuck's on boot screen than boot your phone into stock rom recovery and wipe cache and delvic
4-reboot it
.done!!!!!!
.
.
Related
I was trying to flash clockworkmod touch on my Samsung galaxy note 10.1 (GT-N8013) I accidentally put it in the bootloader section on Odin as opposed to PDA. now the tablet is stuck on the same image as the download mode, although I can access the actual download mode and the recovery. I have tried formatting system, data, cache and dalvik cache. What can I do to fix it?
Edit: I got it working after downloading the stock rom and flashing it first in the bootloader, which put it in a bootloop but got the stock bootloader loaded, then performing a full wipe and flashing it under pda fixed the bootloop.
I just flashed cm10.1.3 and gapps for my p3113. I used twrp 2.6.3 and when I rebooted the system twrp said to slide and install supersu. I did slide and now when I boot the device up I get stuck on the Samsung screen. I also tried to flash the stock rom with Odin but when I reboot, I and it still is stuck on the Samsung logo
PLEASE HELP ME
nathan17 said:
I just flashed cm10.1.3 and gapps for my p3113. I used twrp 2.6.3 and when I rebooted the system twrp said to slide and install supersu. I did slide and now when I boot the device up I get stuck on the Samsung screen. I also tried to flash the stock rom with Odin but when I reboot, I and it still is stuck on the Samsung logo
PLEASE HELP ME
Click to expand...
Click to collapse
brother again flash stock rom via odin
and it happens that when you flash stock rom that you are stuck on sasumg logo
at this point just boot into stock recovery and just wipe cache partition and factory reset { do not wipe anything more that these two things }
you will definitely able to boot after doing what i have said
I am sure you forgot the Factory Reset!
1. Boot TWRP
2. Make a Wipe Data Factory Reset
3. Advanced Wipe -> Data, Dalvic Cache, Cache Partition
4. Flash Rom
5. Flash Gapps
6. Reboot
I cannot enter recovery mode after I flashed the Stock Rom. I forgot to wipe Data Factory Reset Advanced Wipe -> Data, Dalvic Cache, Cache Partition before I flashed the rom so am I screwed?
.now you are on stock? can you enter download mode?
I can get it into download mode
Try flashing a Custom-Recovery in Download-Mode.
Download here: http://forum.xda-developers.com/showthread.php?t=2548257
Uncheck "Auto-Reboot" in Odin.
When Odin finished flashing: Directly boot into recovery from Downloadmode!
same problem
Hi there,
I have the same problem. Tried flashing via Odin and Auto-Reboot ticked off, but still doesnt work.
The flash counter increases, but no boot into recovery :crying:
Try going into recovery and do a wipe data/factory reset then flash the rom.
Hi Guys, Need some help please!
My P3100 had CM11 on it, and one day it stopped booting, was stuck in the Samsung logo. I got into recovery, did a factory reset\cache and dalvik wipe, but has not helped. I got into the Download mode and tried flashing the stock firmware. Odin takes 92 minutes to complete this process, and I can see "PASS" displayed, but tab still stuck in Samsung logo. Infact, when I reboot to recovery after flashing Stock rom, it still takes me the CWM recovery, while I expected to get into Stock recovery. I have also tried flashing TWRP recovery, I get a Pass message, but takes me to CWM recovery again. I have tried flashing custom ROMs from this recovery, dont get any error, but tab still wont go past the Samsung Logo. Out of ideas now, please help!
Boot into Recovery
- wipe data factory reset
- wipe cache
- wipe dalvic cache
- format system
- flash new ROM (if you flash stock ROM CWM/TWRP recovery will be overwritten during first boot)
I have tried that. Several times. The CWM recovery seems to be permanently stuck to the tab. Even if I flash twrp recovery, the flash is successful, but I go back to CWM recovery.
after i reboot to recovery and wipe my data everything done but when i reboot nothing change
and i tried to flash new firmware but nothing change
in downloading mode the status is custom even after flashing new firmware ?
Yes
Yes i get Pass after flashing but when i go to download mode it still custom
I was just doing factory reset on my phone, when it went into bootloop. I didn't do it through recovery but I used reset from phone settings. It always worked well for me. I have phone rooted and I didn't install any custom recovery. I also wiped data and cache from recovery mode, after the bootloop occurred, but the phone is still stuck in it. The phone doesn't have SD slot. Is there any way to recover from this?
jakupsob said:
I was just doing factory reset on my phone, when it went into bootloop. I didn't do it through recovery but I used reset from phone settings. It always worked well for me. I have phone rooted and I didn't install any custom recovery. I also wiped data and cache from recovery mode, after the bootloop occurred, but the phone is still stuck in it. The phone doesn't have SD slot. Is there any way to recover from this?
Click to expand...
Click to collapse
1) you could flash a custom recovery and install a custom ROM
2)flash stock ROM using sp flash tool (ask if you don't know how to use the tool)