I've got a damaged Moto G (usb Port died) and I've added some wires to feed it with Power. But I don't need/want to insert the battery. If I apply 5V, the phone turns on the 0% battery Screen. I can enter the Bootloader but not Recovery.
Is it possible to force it to turn on?
Related
I recently bought a chinese tablet (Sumvision Cyclone Voyager). I found that it wont charge past 92%. After much research i discovered that the problem can be fixed by one of the following:
-removing the battery
-wiping battery in CWM
-Full discharge until off, remove battery, hold power 30 seconds, replace battery charge to 100%
But most of these things require removing the battery or using CWM. What if the battery is non-removable? Or you cant get CWM for you model?
FIX for LiPo non removable (very simple)
I found the fix is:
1. Full discharge until it turns off
2. Full recharge while off until it stops charging ( will prob get stuck at the last bit (92% in my case but when off it dosnt give percentage just keeps showing animation for last 1/3 of battery to be charged)
3. Remove charger and power on the device. Use it until it drops below 80%
4. Recharge again while its on until it gets stuck at X% (92% in my case)
5. This is the important part: while its stuck charging remove the mains plug from the socket on the mains while leaving the connector plugged into the device (dont turn switch off at wall actually unplug the ac adaptor from the mains socket)
6. wait 30 seconds and plug it back in to the mains socket.
-Leave and see if it charges. It may not work the first time. For me it worked on the 3rd attempt.
I installed MoKee rom ( from this thread http://forum.xda-developers.com/showthread.php?t=2699446 ) and after a day of normal usage my phone discharged to the 0%.
Now I plugged it to the charger but won't turn on, only the green light turn on.
I removed the battery and reinstalled but the same.
I used different battery charger, but won't turn on..
What can I do?
All these charger have 5v output, 1.0A output.
I don't have original photon Q charger.
PS: battery is cold, seems that charger is not charging.. after some minute the green led turn off until I disconnect and reconnect the cable
nagash91 said:
I installed MoKee rom ( from this thread http://forum.xda-developers.com/showthread.php?t=2699446 ) and after a day of normal usage my phone discharged to the 0%.
Now I plugged it to the charger but won't turn on, only the green light turn on.
I removed the battery and reinstalled but the same.
I used different battery charger, but won't turn on..
What can I do?
All these charger have 5v output, 1.0A output.
I don't have original photon Q charger.
PS: battery is cold, seems that charger is not charging.. after some minute the green led turn off until I disconnect and reconnect the cable
Click to expand...
Click to collapse
You have 3 options to fix it
1. you must connect other battery must be 3,7v to your phone mb with some wieres and flash some other rom , if this no help flesh stock soft with RDS lite
2. maybe somebody have photon q in your area and he give you battery for 10 - 20 min or charge your battery in his phone
3. buy / make motorola usb service/factory cable ( when you connect your phone with this cable you will be able to flash stock software even if you have dead battery )
a) make your own - http://forum.xda-developers.com/showthread.php?t=1077414
b) buy - http://www.ebay.com/itm/MIcrousb-Mi...=Laptop_Adapters_Chargers&hash=item3a8501224f
regards
Hopefully I am nailing my moto G since purchase after every third day I come in a condition to dump the mobile and buy other one.
So if your battery is not charging
Symptoms:
1. Fully discharged: No sign of Charging
2. Charging screen doesn't come, or LED do not blink
3. Charging Screen comes and led blink few times then again off
4. After continuous flash of LED, charging screen comes with 0% battery charging sign and after pressing power button it goes again and this process is repeated when your press the power button again and again
5. Fastboot/ bootloader screen comes but not charging.
etc.... few other symptoms
Solution
1. Charge your mobile with any 2. Amp charger (2A is well written on your charger)
2. Leave your phone after fully discharge (no LED blink after pressing power button for any seconds), then put it in deep freezer / or in ice chamber for not more than 10-15 minutes (cover and wrap your phone in poly cover and paper before ) then take out your phone and charge with good charger (more than 1 Amp power) and do not press any button unnecessarily.
3. Press volume down and power button to go to boot menu then/before plug your charger and wait for normal power up.
In hard time, no way you are going to power up your phone with worst moto G original 0.5 A charger if battery is exhausted below zero.
Use 2.0 Amp Charger to wake up again your phone.
or keep it in freezer for 10 minutes then again charge with 2A charger
I faced many kinds of charging problem but nothing works except this.
I have replaced the screen but the cable flex of the battery has broken. The phone don't respond NOTHING plugged to charger or the pc.... NOTHING.. (edit: red light only for 1 minute or 2)
I don't want to buy a battery if the phone is broken, or the new screen is not working....
Z3 must boot plugged to pc without battery connected?
Thanks
Dear all,
I found an old Moto G (1st gen) and I want to use it as spare phone but it doesn't turn on. When I plug to charger, white led turn on (fixed) but phone doesn't charge even if I left overnight.
I tried: 120 sec hold power on button, 120 sec hold power on button + volume down, different chargers up to 2.4A, disassembly and left battery unplugged for 30 min, connect charger without battery. No way.
Any other suggest? I suppose that with battery unplugged and charger plugged the screen have to turn on https://www.youtube.com/watch?v=qZhAabwi24M
so the problem is not the battery. or not?
Please help. Best regards
no one can help me?