hi there
i am using imate jamin da problem with my cell is
i upgraded my rom to qtek 2.20000 it was working absolutely fine with 8 icons in my comm manager then i upgraded to RUU-Prophet-G4-AKU2.2-2.20-2.47.21-Jester-b1 and it has severely damaged my cell as my phone my phone hangs white booting it shows me the colour screen with
IPL 1.00 and SPL 2.20.0001
on the Screen
OS and GSM is not displayed
I tried rom update several times but its not working
i tried to update my rom through boot loader mode but again failed
i even tried to format my phone but it gives FAT16 format failed
I even tried to upgrade to jesters RUU-Prophet-G4-AKU2.2-2.20-2.47.21-Jester-r1 but still its not working and givng same problem
now i dont understand what to do
guys please give me Advice and solution for this g3 g4 Problem
i even tried sending my phone to service center but stupid people dont know how to solve it and they returned me back
Thanks in Advance
You have bricked your phone... You just can't install a G4 rom on a G3 phone... Different chipsets are the cause of the problem... Sorry
you mean to say its over ?????????????
there should be any way
You'll have to wait to see if Jesterz manages to produce a goldcard...
BTW a goldcard it's basicly a mem card with a rom in it that autoinstalls itself thus no need for the usb connection... This fits your case cause you don't have an active usb conection because of the driver/chip conflict...
wrong software
I have the same problem i tried to flash my g3 with jesters RUU-Prophet-G4-AKU2.2-2.20-2.47.21-Jester-r1 by mistake and it was ok until the end of process when i finich it with congratulations and bla bla my device stills in the bootloader mode all the time. I can now connect and start to flash but when it comes to 80% of the process it stops with error 360 wrong command. Pleas is there any help for some kind of downgrade flash or so because it can only get boootloader but never start with software. When I try with jesters RUU-Prophet-g3-AKU2.2-2.20-2.47.21-Jester-r1 the whole process finish ok but the phone stills in bootloader. The same thing is also with RUU-Prophet-g4-AKU2.2-2.20-2.47.21-Jester-r1 I can not execute step2
that's why you should read the "sticky" first before you do it.
I have a Dopod 818Pro from a friend of mine but in Chinese ROM, so I have to read a whole nite the sticky and found out what is my Dopod version, finally I found it is G3, so I did all the steps, from unlocked the CID till upgrade to Jester latest ROM for G3 and skip the G4.
please help
Yes i realy know that it was my fault and my big mistake so i vould not do it again but now i need help because it stills in bootloader i i can even start flashing the device that gives me hope that some kind of recovery is maybe possible.
Yes i also commited this mistake its my fault but i really need help my device still enters into bootloader mode.
ur problem
there is nothing to do anymore u have to wait u CANT DO ANYTHING ITS OVER
how do you mean it is over. Do you think that could not repair it. Is it possible with sd card or jesters gold card and how. Help me please if somebody knows
there must b some way to overcome this problem
jesterz's gold card isn't working yet, and for now it's only for G3...
My hardware is G3 but flashed by mistake with G4 and now is in bootloader mode so i can start flashing but i do not know with what and how. Could you please explain me how and where can i find and use goldcard for g3 if possible Thanks
have u tried holding the camera button while softreset and then flash rom again
Yes sure i tried to flash rom from jesters for g3 which is for my device instead jesterz g4 what i used by mistake and it passed ok but when i restart it stills in bootloader mode only, so i could flash but do not know which firmware should i use
i've the same symptomes as mjankovic and aarif_ziaee, (bricked my phone)
but the only things i think i've forgot, is to cid unlock my device before doing the step 2
i have a question.
i have the rom PDAMobiz_Prophet_WM5AKU3.3_v3301
(witch is not an auto installable tile, it's a folder containing exe, dll, bat and nb file)
is it possible to install it by using teraterm pro or mtty? (connected and install bats and cabs by thoses software)
ps : i'm sorry for my bad english, i'm french not going to my languages faculty since i'have bricked my phone. need to fix it soon !
Hi All, I have bricked my SCH-I925 (Verizon) And need some help.
What I have done so far:
I unlocked the bootloader with the tool from AdamOutler
http://forum.xda-developers.com/showthread.php?p=41016954
It workt just fine, but after a wile I tried to do a factory reset. After that it was not booting anymore and always ended up in TWRP.
I then decided to do a system repair to factory rom with the Verizon tool, This went wrong and now it is not booting anymore. I can enter ODIN mode but it will not accept any roms, Also the Verizon repair tool is not able to load the factory rom and get stuck on 83% falling back to 66% with the message the device is unexpectedly disconnected.
What I have now is the unencrypted factory rom grabed it from the Verizon tool when it was trying to write it to the device. And a Unit that will not accept any writing of roms.
Does anyone know how to resolve this problem?
I also have access to a RIFF-Box and second working SCH-I925 but unfortunately no info about the JTAG pinout of the device.
hope to help
Hi, I've looking for the tool CASUAL(R478b) everywhere , but I can't find it anymore ,the link has expired. Can you share it to me please. Thank you very much!!!!
Or ,you can email it to me :
[email protected]
Thank you again!
Not sure who you are asking as OP was seven years ago .
Posted an email is liable to get a flood of spam .
Hi, i m javed
I need help i had rooted my friends ot918n idea 3g phone by following a guide on xda but since then i m facing problem, i m not getting incoming calls and i m unable to reset this phone, whenever i try to reset it boots into recovery and i tried 3 different roms 1stock n 2 custom and all the roms installed successfully but the phone gets stuck in boot screen after installing any rom. I tried to update it via one touch upgrade but always get network error dont knw why. And i also tried hard reseting it but i never get android logo with triangle it always goes into recovery.
After googling for two days for the solution i tried many things but no luck. I just want to install any stock or custom rom and phone should work fine so that i can give it back to my friend.
This is my last hope to get a solution from u guys.
Plz help me.....would appreciate a quik reply its urgent...
Need help plz reply.......
Hey guys, I've been attempting to root my Sonim XP7 and everything seemed to be going well until I rebooted a couple days ago, now it is stuck at the sonim boot logo. I've tried wiping and factory resetting it from recovery and it gives a successful data wipe message but continues to get stuck at the boot scree. I have no idea what to do. I imagine I already lost all data on the phone but i'd really like to get this phone working again. Can anyone guide me? Thank you
Hi !
Unfortunately I couldn`t find anything helpfull for you here on XDA , next time you must search deeper before proceeding to modify your device , confirmed tools must be considered
Now , the only thing I can suggest is to either contact the seller or the manufacturer in order to get it back on track .
Good luck !
Hello, my Motorola e Android phone got hard bricked and it began suddenly with the first error message being constant boot looping and eventually going to an error message with an adroid on its back where it said partition was corrupt or damaged and the only choices were try again or factory reset. I kept trying again.
I tried to fix it and eventually ended up stuck on ap fastboot flash mode(secure) and it says oem locked.
I gave up trying to do it myself and want to factory reset but recovery mode won't work even if I press it, says that start up failed and goes back to fastboot mode. It's stuck.
Serial number is ZY22DLT4R and last letter is a V or W, can't tell.
I dont know to flash or custom rom. Tried a few but I only have windows 10 on my PC and it didn't install drivers properly and I need this phone fixed ASAP . I think I'm considered a newbie.
I also need to know if it's too far gone so I'm prepared to buy another crappy phone and lose all my data. I don't have days/weeks to learn tutorials about how to mod, etc.
Please help.
edit: I don't know if my bootloader is locked or unlocked.
Re-flash phone's Stock ROM by means of this tool
Download Moto Auto Flash Tool v8.2 by Jamesjerss (2022)
Download Moto Auto Flash Tool v8.2 by Jamesjerss to flash Firmware on Motorola Phones. Follow this guide to Root, Unlock Bootloader, etc.
www.ytechb.com