[Completed] Lenovo s850 accelerometer calibration error - XDA Assist

Hi.!
Recently I have buyed lenovo s850 it is working good, but a few day ago there is a problem when I opened camera my phone is directly going into landscape mode even when I hold it in portrait and I showed it in lenovo servicing centre also they checked but said nothing is wrong, they even flashed new firmware but no change finally they said it is an mother board problem, they said that it will take 12 to 15 days to change the mother board from factory, but I didn't like that and I brought my mobile to my house and tried to caliberate my g.sensor it worked some good but it is not staying for a long, I have downloaded accelerometer test apk, it is saying that caliberating (10.2px) when ever this process takes place my sensor works nice but after that it will retrack back, so sir is there any solutions so that I can correct my calibration error values. Thank you

Hi
Unfortunately we don't have a dedicated forum for your device.
Try posting in the following thread to get help: http://forum.xda-developers.com/showthread.php?t=2257421
Good luck.

Related

[Q] Huawei ascend P2 blank Imei blank no signal

Hi all, occasional xda reader for many a year finally registered.. if wrong section, apologies.
Long story short, living room was ice cold and very damp, mobile fell underneath duvet/quilt by accident, after retracing previous journey eventually found phone which was dead.. flicking phone produced liquid, took back off to find a lot of condensation.
Dried out over 2 days, charged and all seemed well except no signal.. *#06# is blank baseband version says unknown.. took to local mobile repair shop, he says reflash didnt work although my browser history is still present would that of been wiped??
Is phone fixable or broke, last phone i flashed was a nokiz n900, not into techy it stuff no more, i have a android tab an maybe access to a win laptop..
thanks for any help
(trying not tk hate huawei but this aint first problem but they are a nice handset)

[Completed] [Q] Sony Xperia Z display problems after replacement

Hello everyone
It's been a while since I have had a problem with a device that I repair but unfortunately it has happened again today.
Today at 5 pm a friend of mine came by with his xperia z to replace the screen. I first run through the tutorial and see whether I came across something I do not know. Then I just started the repair and took my time to complete it. I finished at 19:30 pm. I also installed a new parts I've replaced the display and the on / off volume flex cable. After having successfully placed everything the most exciting moment of the evening followed, turning on the device. The 1st time I turned on the phone it worked so well. I did some tests and turned the phone a few times on and off to see if that would not cause any problems. But after 4 times the phone only showed the backlight. I have been through all the connections and also did an disassembly again to see if there might be a flex cable that is not properly connected but I could not find anything.
Now my question to you is fellow members, would anyone here help me or has anyone here had previously experienced.
With kind regards,
0ViP0
Hi,
Here is a guide on that.... You could ask about your issue here too..
http://forum.xda-developers.com/xperia-z/help/sony-xperia-z-screen-repair-guide-t2417650
And here's a section dedicated to your device and screen issues. You can browse through here, or start your own thread if you still need help,
http://forum.xda-developers.com/xperia-z/Display
Good luck!
thank you

[Completed] [Q] Touch screen stopped working chinese phone No.1 X-men X1

Hello!
Last week i just got my No.1 X-men X1 phone. Yesterday when i was on fb messenger it froze while i was taking a picture, but i was still able to reboot the phone normally from the screen. When it turned on again the whole touch screen stopped working. I don't think it's hardware because the phone was only in my hands when i rebooted it..I went into recovery and wiped everything i could (it still has everything original) and it didn't help. The phone did have a weird task manager installed (DU Battery saver or something like that) maybe that broke the driver? I am a newbie with chinese phones and really need help!!!
If there is someone that can help me please respond because i don't have any other phone now.
Best regards
Tina D.
Hi
Thanks for writing to us at XDA Assist. Unfortunately I can't find anything relating to your device on XDA. It might be best to contact the manufacturer or seller and claim warranty as it is defective.
No response in two days, thread closed.

[Completed] Screen flickering Meizu m2 note

Hello, I actually have a small problem on my phone.. I searched for the solutions but I am unable to find a reliable fix.. Everybody has a quite different type of this problem..
Phone model: Meizu m2 note
Previous os : Flyme 5(stock)
Current OS: Cm 12.1 (by Moyster on xda)
SCREEN FLICKERING
Well, before I start I would like to say that my phone has actually survived a water bath.. The phone fell in the swimming pool when my friends were trying to click a pic.. It didn't switch on, on the same day, but I disassembled it completely, and let it dry for a week.. Later the phone worked completely fine.. It's been 3 months since the incident...
Well the problem now is the SCREEN FLICKERING.. I guess It has nothing to do with the water damage cause that was almost 3 months back and this problem started around a month ago, when I was on flyme 5. And nope, the phone has never fallen off my hands.. The phone works fine for maybe the first 30 minutes after keeping it idle for a long time... The screen flickers even during the bootup, fastboot, and even in recovery..
I have two Meizu m2 note in my home.. The other one is my mom's phone.. And I almost update same roms on both the phones.. And my mom's phone is working completely fine and not facing this problem.. I don't have a warranty for this anymore, but I can still give it to the company's service center.. The main reason I posted this thread is because I just wanna know if this is a software or a hardware problem.. Cause in few other threads they said that this had sumthng to do with the kernel and stuff.. I don't wanna leave my phone at a service center for 2 months if this is fixable at home..
Not the complete screen flickers, but only the upper top part of the screen..
I have attached a YouTube link for a perfect view of the screen.. The phone on the video is my phone..!
https://youtu.be/Bw1QVspTw7M
I would really appreciate if you would help me on this.. thank you.. :victory:
Hello and thank you for using XDA Assist,
please ask here:
Android Q&A, Help & Troubleshooting
Best regards
Trafalgar Square
XDA Assist

[Completed] gt-s7582 having a rare issue with phone

I really don't know if this is a right place or not but i want to mention it here, this started when i accidentally leave my phone at heavy rain. It stopped working for 2-3 days and when it started i found total loss over touch, i replaced it and then it was working fine except... its proximity and other sensors are not working and it take almost 5 min to turn on, i though it may be hardware issue, but than after some days it reboots normally and everything was working again except proximity, it remains this good for a while even doesn't get affected by reboots but then again everything was gone, after that day it happens for few times, i didn't recognise what made it go smoothly and than what made it worst again, help me with thar pls.... I also see color stripes for a while clicking on cancel in download mod....i'd installed stock rom more than 2 times and now on CM14.1 help me.....
Vishal Shrivastav said:
I really don't know if this is a right place or not but i want to mention it here, this started when i accidentally leave my phone at heavy rain. It stopped working for 2-3 days and when it started i found total loss over touch, i replaced it and then it was working fine except... its proximity and other sensors are not working and it take almost 5 min to turn on, i though it may be hardware issue, but than after some days it reboots normally and everything was working again except proximity, it remains this good for a while even doesn't get affected by reboots but then again everything was gone, after that day it happens for few times, i didn't recognise what made it go smoothly and than what made it worst again, help me with thar pls.... I also see color stripes for a while clicking on cancel in download mod....i'd installed stock rom more than 2 times and now on CM14.1 help me.....
Click to expand...
Click to collapse
Greetings and welcome to assist. If returning to stock doesn't work then it must be a hardware issue I'm afraid and there is little we can do to help with that. Really hope you manage to fix it
Good luck
Sawdoctor
Thank you very much for your help, now at least i know what I'm dealing with....... I'm expecting that my service provider will help me with this, thanks again

Categories

Resources