[Completed] Cyanogenmod 12 for HTC Daul Sim (Network issue) - XDA Assist

Hello
I recently flashed CM12 nightly offical rom
I am liking it very much but i m have trouble with the network settings
Dual Sim
Sim 1 - 3G Data Only
Sim 2 - Calls only
Now when i set LTE network mode on sim 1 and do the *#*#4636#*#* i get the H+ working but the sim 2 setting switches to 2G which causes calls to loose all incoming/Outgoing audio...
and when i set LTE on sim 2 calls work fine but then sim 1 switches to 2G causing low speed untill i manually change that back...
I have searched lots of thread but found no working fix for it for my HTC 816 daul sim
Kindly guide me to the thread where i can get my problem fixed permanently..
Thanks

Hello, thank you for using XDA Assist.
Post this as a bugreport in the XDA Thread of the ROM you're using. Make sure you're on a clean flash though. The experts there should be able to assist you.
Good luck!
Sent from my LG-H815 using Tapatalk

Related

[Q] Not getting 3G data in Slot 2 (running AirTel)

Hello All,
I'm using the One E8 with the following combination:
Slot 1 - Reliance CDMA UIM
Slot 2 - AirTel SIM
My requirement is to use the Reliance connection for voice and AirTel for both voice and data.
Having said that, I've selected Slot 2 to be my preferred data slot and have the default APN settings.
The Slot 2 is just not getting H or H+ (i.e. 3G signals) at all.
I'd read a couple of forums which say
"SIM 1 has 3G but SIM 2 only supports EDGE speeds"
source: http://unleashthephones.com/2014/08/01/htc-one-e8-review-2/
Click to expand...
Click to collapse
Is this true?
Please help me out in getting my requirement work well.
Many Thanks,
Vinay
Yes only SIM 1 has 3G
Could you please send me link to your installed rom?
iamsuperuser said:
Yes only SIM 1 has 3G
Click to expand...
Click to collapse
Thank you.
I also checked with their technical support team.
It seems that Slot-1 can do 3G but Slot-2 can do 2G only.
In my case, I'll have to go back to Airtel and disable 3G and enable EVDO services with Reliance which is used in my Slot-1.
ansi_11111 said:
Could you please send me link to your installed rom?
Click to expand...
Click to collapse
This ain't a Custom Rom; It's a normal stock version.
Dear @vinay.habib yes I knew that I have HTC one E8 M8SD China version and i had a problem with CDMA uim slot 1 was not accepted but when installing custom rom gsm/gsm both working well so I spent a lot of time to find another version supports CDMA but nothing till now could please send me any link for a custom rom support CDMA or if possible to send me a TWRP backup of your stock rom thats will make me very happy.
ansi_11111 said:
Dear @vinay.habib yes I knew that I have HTC one E8 M8SD China version and i had a problem with CDMA uim slot 1 was not accepted but when installing custom rom gsm/gsm both working well so I spent a lot of time to find another version supports CDMA but nothing till now could please send me any link for a custom rom support CDMA or if possible to send me a TWRP backup of your stock rom thats will make me very happy.
Click to expand...
Click to collapse
ansi_11111,
I understand your problem here...
But it might take me sometime to create a TWRP backup of my ROM as I'm to tied up with things at the moment.
Will notify you once done.
Dear all!
Thanks for the ones who tried helping me out here.
I now have my worries addressed very well.
Slot 1 - CDMA (carrier - Reliance, India)
Slot 2 - GSM (carrier - Airtel, India)
The slot 1 now has EvDo-rev.B activated and the data speed is just amazing!
The slot 2 had 3G activated, but now that data connection is taken care with slot 1, I'm gonna terminate my 3G services and continue with EvDo-rev.B.
Must say, E8 is such a masterpiece! :good:
vinay.habib said:
Dear all!
Thanks for the ones who tried helping me out here.
I now have my worries addressed very well.
Slot 1 - CDMA (carrier - Reliance, India)
Slot 2 - GSM (carrier - Airtel, India)
The slot 1 now has EvDo-rev.B activated and the data speed is just amazing!
The slot 2 had 3G activated, but now that data connection is taken care with slot 1, I'm gonna terminate my 3G services and continue with EvDo-rev.B.
Must say, E8 is such a masterpiece! :good:
Click to expand...
Click to collapse
Nice to hear that but What did you do? to make it working.
ansi_11111 said:
Nice to hear that but What did you do? to make it working.
Click to expand...
Click to collapse
I got myself a new nano-SIM from Reliance (the CDMA carrier) for slot 1 as the one I'd got cut into nano-size was too old.
And also got the EvDo services activated on my number.
Ergo, connection succeeded.
This is only for the cdma version right? Or can a person use a cdma SIM in the HTC one e8 gsm gsm ?
Swap cards
Couldn't you have just swapped the cards around?
Guys, thanks for your suggestions, but sorry for replying late.
gregferns said:
This is only for the cdma version right? Or can a person use a cdma SIM in the HTC one e8 gsm gsm ?
Click to expand...
Click to collapse
Yep, you're right - this is the CDMA version, precisely M8sD, Dual.
And a CDMA SIM can't be used in a GSM-GSM!
jackerhack said:
Couldn't you have just swapped the cards around?
Click to expand...
Click to collapse
I would love to do a swap here.
But for my requirement with CDMA and GSM running...
One must do this:
Slot-1: CDMA
Slot-2: GSM
The swap won't work in this handset as Slot-1 supports CDMA/GSM combination and Slot-2 is only GSM.
Moreover, I'm now happy with Reliance EvDo.rev-B running at superb speeds with no need of Airtel 3G at all!

Moto G 1st Generation: After some time second SIM slot of my phone stop working

Hi All,
I have i have 1st generation Moto G(Dual SIM). My mobile's sencond SIM is not working properly. I see a plus sign instead of Network Bar in notification bar and if somebody calls me on that number he gets the message that the number is switched off. To enable that SIM i have to disable the first SIM and after that if i enable the first SIM then both SIM works for sometime. But after few hours sencond SIM again stopped working.
Please ask questions in the Q&A section
Thread moved
Did you try doing factory reset...or flashing ROM stock again...(I suppose u r on stock)
Sorry bad English...
Enviado desde mi [email protected]|¢0π XT-1033
Have u tried with other sim card is the issue persists?
Sent from my XT1033 using XDA Premium 4 mobile app

[Completed] please help....No signal In GSM/2G Mode, But 3G/HSPA working fine

I was browsing the net and suddenly the mobile freeze and i had to reboot it.
Then there was no signal and then i changed to WCDMA(or 3G ) mode and it worked fine.
This problem is with both the SIMS( one airtel sim & other idea) suddenly. I can use 3G but cannot 2g.
When I manually search The network operator in the GSM/2g only mode by settings>more>mobile networks> network operators>manually then I can see that the 2g network of both the operators is available and when i click on that network then it just shows " Registering on network...." for 2 minutes and then it says "can't connect to this network right now, try again later" ,both the times I search the network manually for each Sim.
I have flashed stock Rom twice and had factory reset, but the problem still persists.
Please help
Device: Micromax A210(Canvas 4), Android 4.2.1, V16 stock rom
Hello,
Thank you for using XDA Assist.
Previously one of our XDA Assist Staff members guided you to the forum where you need to be looking for your information and asking your questions. Your device has a dedicated forum. In this original post of yours is where you received the guidance http://forum.xda-developers.com/showthread.php?p=62584399
Please continue to go and search and seek help in the device forum.
Thank you
Ragnar

[Completed] cm-12.1-20150918 build datacom not working on the sim with voice

Dear Rox,
1. First of all gr8 work on giving 5.1.1 aka new life to s3 neo users.
2. Just installed the latest build of CM 12.1 relelased on 21 sep 15.
3. It was mentioned that there will be no audio in call in the second SIM. I have a different problem. There is no audio in SIM 1 but audio is there in SIM 2. Also DataCom 3G works in SIM 1 and no datacom 3G/2G in SIM2. So technically eighter I can use the phone for calling or only for 3G as the two things are not working together on a single SIM.
4. Pl help as my enjoyment of Lollipop 5.1.1 was very short lived. Will be greatful.
Hi
If you simply post in the rom thread, as a new member, your post should be automatically directed to a Q&A thread for the rom you are referring too.
That is your best way to find help. You can ask for help for this or anything else here too,
http://forum.xda-developers.com/galaxy-s3-neo/help
Good luck!

[Completed] My jio sim not working after rooting my moto x play

Hi guys....I have rooted my moto x play recently.. I have unlocked many root features and its stunning...but my reliance jio sim is not working in my mobile..what may be the problem???...if I insert jio sim normally it will show a volte notification near the tower notification on top..but I'm not getting that notification now....please help me to solve this....please give me some solution to make my jio sim work...
XDA Visitor said:
Hi guys....I have rooted my moto x play recently.. I have unlocked many root features and its stunning...but my reliance jio sim is not working in my mobile..what may be the problem???...if I insert jio sim normally it will show a volte notification near the tower notification on top..but I'm not getting that notification now....please help me to solve this....please give me some solution to make my jio sim work...
Click to expand...
Click to collapse
Hi,
Kindly register yourself at XDA post which you can post your query in http://forum.xda-developers.com/moto-x-play/help
Experts there may be able to help you

Categories

Resources