Can anyone tell me if you're able to SSH to other devices connected to the wireless connection created by your android phone? I'm in dire need of a password-less connection right now but not sure if it will work. Campus wireless has a stupid terminal where you need to put in your password in the web browser before using it which doesn't work for what I'm trying to do.
Yes. I can ssh (via BTEP or ConnectBot) to other machines in my LAN via WLAN.
I'm using CM9 on my galaxy nexus.
I can connect to my PPTP VPN server (my router running tomato) fine without tunneling, both inside my lan, and outside it.
I can connect to my SSH server (again my router), both inside my lan and outside it. And have successfuly forwarded ports before w/ connect bot and remote desktop apps.
But everything I try results in my VPN connection timing out when I try to do it over the SSH tunnel. I have it connecting to localhost on the VPN settings side. And on the connect bot side i am forwarding port 1723 to 192.168.1.1:1723 (which is my routers lan IP).... but it still times out.
Does anyone have any ideas? is this even possible?
Hello.
I need some help about my problem connecting to my work lan.
I have a PC in office connected to work LAN. I can connect to my pc from remote usign SSL VPN.
I have installed Junos Pulse on my Galaxy Note 10.1 and with it I can connect to my VPN and then, using port 3389, I can connect to my PC using RDC.
If I need to access my work network, I need to make some tunnel using port 3389.
I installed SSH server listening on port 3389 on my pc and, after VPN connection has been established, I try to use SSHtunnel to configure connection to my ssh server (working ok) and then starting Global Application routing. When I start SSH tunnel it connect to my ssh server and it works (for ex. using internet browser from android) but only using IP addresses.
If I try to use names instead of IP it is unable to resolve DNS, also if I set DNS option ON in SSHtunnel.
I cannot understand how to accomplish that kind of connection. I tried proxydroid, sshtunnel, autoproxy but they does not work (or I am not able to make them work).
I don't know if it is some problem using tunnelling with Junos pulse.....
Any help for me?
Thank you
No help?
Hi,
I want some software or command-line commands to make my Samsung Galaxy Note N7000 (android 2.3.6) temporarily as NAT router. But I dont want tethering or make phone as wifi router, but instead as wifi client. I want connect to internet through 3g and then route and NAT all incoming packets from wifi connection to 3g. So, my client computer is in LAN, in LAN I have wifi router, computer client connects to internet through: computer client --> LAN router --> phone wifi-client (phone wifi client makes connection to wifi router) --> phone NAT and routing --> phone 3G network connection --> internet.
Thanx.
Hello Experts,
I am not a super expert but working on it on own interest basis.
My situation is,
I have one broadband connection thru ADSL+wireless router.
Normally my PC & other android devices at home are connected to wireless router of broadband.
Sometimes, this broadband connection fails for a couple of days.
I have one Android 6.0 mobile device which have unlimited data plan, but other android devices like mobile, Tabs does not have data connection.
During that time,
I create a hotspot & share to other wireless devices, but my PC does not connect until I connect thru USB tether.
Is it possible ??
To make a bridge in android 6.0 MM, between data connection & wi-fi ?? (I will connect it to wireless router with out hotspot), & set the DNS & gateway manually in the PC & wireless router.
What I have already done
Connected my mobile having data conn to win 10 PC with USB tether & PC is also connected to adsl router thru LAN.
Now,
I have checked the address of USB tether network IP (192.168.XX.XX), gateway (192.168.XX.XX) & DNS (192.168.XX.XX).
Then I created a bridge connection at PC between ADSL LAN & Tether Connection. Set above mentioned IP, gateway & DNS at created bridge connection.
Then I logged in into ADSL router,
Changed its IP from 192.168.1.1 to 192.168.XX.XX ( matching with USB tether conn except last digit).
Then I connected all my android devices to ADSL router wireless network & manually set the DNS address to every network same as USB tether DNS.
profit :
Not much, But I am getting a strong wifi network signal from ADSL compared to mobile hotspot & all my devices connected to internet being at different places of home with different people.
My above query was to get rid of USB tether in this situation.
Thank you for reading all above & suggestions if any.
[email protected] said:
Hello Experts,
I am not a super expert but working on it on own interest basis.
My situation is,
I have one broadband connection thru ADSL+wireless router.
Normally my PC & other android devices at home are connected to wireless router of broadband.
Sometimes, this broadband connection fails for a couple of days.
I have one Android 6.0 mobile device which have unlimited data plan, but other android devices like mobile, Tabs does not have data connection.
During that time,
I create a hotspot & share to other wireless devices, but my PC does not connect until I connect thru USB tether.
Is it possible ??
To make a bridge in android 6.0 MM, between data connection & wi-fi ?? (I will connect it to wireless router with out hotspot), & set the DNS & gateway manually in the PC & wireless router.
What I have already done
Connected my mobile having data conn to win 10 PC with USB tether & PC is also connected to adsl router thru LAN.
Now,
I have checked the address of USB tether network IP (192.168.XX.XX), gateway (192.168.XX.XX) & DNS (192.168.XX.XX).
Then I created a bridge connection at PC between ADSL LAN & Tether Connection. Set above mentioned IP, gateway & DNS at created bridge connection.
Then I logged in into ADSL router,
Changed its IP from 192.168.1.1 to 192.168.XX.XX ( matching with USB tether conn except last digit).
Then I connected all my android devices to ADSL router wireless network & manually set the DNS address to every network same as USB tether DNS.
profit :
Not much, But I am getting a strong wifi network signal from ADSL compared to mobile hotspot & all my devices connected to internet being at different places of home with different people.
My above query was to get rid of USB tether in this situation.
Thank you for reading all above & suggestions if any.
Click to expand...
Click to collapse
Yez and yes, search Hack5 in youtube and find the video relating to wifi pineapples( the bridge/router) and you will find everything you need , along with EasyTether pro(works fully tested to bypass tethering restrictions) . I dont know how the pineapple/router works but I know EasyTether uses adb to take and make a usb tethered connrection, then with a moderate-advanced setup(ie. wifi pineapple) you will be broadcasting wifi to any device you need. The only downside is you have to usb tethr to the pineapple at all timez to make a usable wifi,So in my opinikn best to buy anothr $45 a mnth plan especially 4 tethering, tho Im just now switching to a ISP for my internet it did the job, i even freelanced for awhile all remotely using the hotspot/created wifi/bridged connection.Hope that hellps brutha
Th
Tks...Bro...
I did it long before without spending a single penny.
I simply used network hack and bluffed the pc and other devices...It is working like charm....