I Flash custom Rom& getting some problem with the screen, my screen goes off automatically & i have to press volume rocker then it came back for a Second & then goes off again every thing is working fine except screen issue after flashing the Rom.
Plz Help me out
surendra.m said:
I Flash custom Rom& getting some problem with the screen, my screen goes off automatically & i have to press volume rocker then it came back for a Second & then goes off again every thing is working fine except screen issue after flashing the Rom.
Plz Help me out
Click to expand...
Click to collapse
Check if it is a hardware problem.If the problem persists, get your phone replaced.:good::fingers-crossed:
Related
Hello,
I am fairly new to loading roms, but I have done it already several times successfully both on keiser and wizard,
now Yesterday I wanted to try Dutty's V1 rom and I did, now when it completed it started to boot, with the htc splash screen customized with Dutty's name etc, then it asked me to calibrate the pen, you know the normal stuff.....then it stopped booting it will get stuck into a white screen,
and it stays there, it will not active sync, it starts fine, I read: R 1.65.16.24
g 25.83.40.02W D 3.5Dutty's . then it gets into this white screen and stays till the backlite goes off, if I tap the screen the backlite goes back on, and one time I was able to hold the off button and I got even a message saying " if you disconnect them you might lose some data, continue yes or no". Tapping no or yes made no difference.
Please Help, I need to enter bootloader in some way, please help !
can you enter bootloader mode?
keep the camera button pressed and soft reset with ur stylus....or turn off ur phone and keep the camera button pressed and press the power button of ur device...
if you can enter bootloader mode...just reflash dutty's rom or maybe flash some other rom and you should be fine
Once it started to calibrate the stylus is when you Hard reset.
Please Help, I need to enter bootloader in some way, please help !
Click to expand...
Click to collapse
You definately need more lecture.
recently i installed Salvy.C.83_Megan_v1.4_WWE_Polaris_EzInput_2.1 rom
after than my phone worked fine for two hours but after that suddenly switched off and now its not working
it just struck on starting screen
where smart mobility is written
please help me
thanks in advance .............
Go in bootloader mode (press camera & soft reset), and flash your rom again.
After you installed it, hardreset your device!
really thanks dude
a lot of gratitude to you
what's the (press camera & soft reset) button i know the reset button i dont no about the camera can u plz tell me fast coz my phone as stop working and its stuck on htc white screen...((
Just press the Camera Button on the Bottom Right the same time you press the Reset Button.
Hi, I've had this issue, reflashed the ROM, after one or two days of use, it happens again, reflashing only revives the phone for 1 or 2 days until it gets stuck into the bootloader screen again
Does anyone have any suggestion ?
Before this,my phone got a problem but it was fixed(bootlooping)
But then about 6 months later a new problem happened,I press the power button,it shows this,then vibrates and freezes....just like that.
I'm not sure if the image is loaded because I had to use my tablet for a while.
Any suggestions on how to fix this? And my phone is not rooted btw.
teeneedshelp said:
Before this,my phone got a problem but it was fixed(bootlooping)
But then about 6 months later a new problem happened,I press the power button,it shows this,then vibrates and freezes....just like that.
I'm not sure if the image is loaded because I had to use my tablet for a while.
Any suggestions on how to fix this? And my phone is not rooted btw.
Click to expand...
Click to collapse
This is a bootloop issue just like cwm bootloop,your device is soft bricked and you can repair it by flashing the stock firmware of your country using odin,don't worry,see in my signature the way to install your stock firmware(CWM BOOTLOOP FIX)
teeneedshelp said:
Before this,my phone got a problem but it was fixed(bootlooping)
But then about 6 months later a new problem happened,I press the power button,it shows this,then vibrates and freezes....just like that.
I'm not sure if the image is loaded because I had to use my tablet for a while.
Any suggestions on how to fix this? And my phone is not rooted btw.
Click to expand...
Click to collapse
from an older post i know from a member here that if the phone keeps looping but vibrating (it vibrates every loop) its because the power button is stuck, maybe this helps you
teeneedshelp said:
Before this,my phone got a problem but it was fixed(bootlooping)
But then about 6 months later a new problem happened,I press the power button,it shows this,then vibrates and freezes....just like that.
I'm not sure if the image is loaded because I had to use my tablet for a while.
Any suggestions on how to fix this? And my phone is not rooted btw.
Click to expand...
Click to collapse
Yeah it happened wid me 2.. Have u flashed a new firmware and if u have done so u have to go again to the recovery mode and the "wipe everything"(data,cache). It will surely work..
If I helped u hit thanks...
Hi
I have been helping a friend repair their phone after it got water damaged
THe battery has been replaced and the phone boots and can go into Android
I have since Unlocked the bootloader
Installed TWRP
Rooted it
Installed a Cusom Rom
And installed a Custom Kernel with no issue.
So In my eyes this Phone is 100% working
The Problem i am stuck with is that whenever the phone is turned on it goes straight into the Bootloader screen and the Option bit on the top (Start, Recovery, Reboot BootLoader and Power off)
Constantly scrolls through each option as though the volume key is being pressed
if i press the power button as each option appears the phone will boot into the option i have chosen
While in Android all the buttons work correctly.
Vol up and Down and the power either going to sleep or bringing up the power menu.
Any ideas would be a great help
Probably HW related, but not sure
Sirklip said:
Hi
I have been helping a friend repair their phone after it got water damaged
THe battery has been replaced and the phone boots and can go into Android
I have since Unlocked the bootloader
Installed TWRP
Rooted it
Installed a Cusom Rom
And installed a Custom Kernel with no issue.
So In my eyes this Phone is 100% working
The Problem i am stuck with is that whenever the phone is turned on it goes straight into the Bootloader screen and the Option bit on the top (Start, Recovery, Reboot BootLoader and Power off)
Constantly scrolls through each option as though the volume key is being pressed
if i press the power button as each option appears the phone will boot into the option i have chosen
While in Android all the buttons work correctly.
Vol up and Down and the power either going to sleep or bringing up the power menu.
Any ideas would be a great help
Click to expand...
Click to collapse
after 3 years did u find any solution. exactly same issue happen today :crying:
Try updating to the latest bootloader. But I assume the buttons get stuck sometimes. Try smacking the buttons s a couple of times. Hope that works.
I flashed francor 58 through the franco updater on top of mahdi rom 6/70. When I got boot loops I reflashed r57 (had previously worked) and when it came up I no longer had working volume rocker and power buttons. If I hold down power the device DOES power off. I tried flashing other roms as well as stock and the problem persists.
I did an e2fsck on data and a factory reset with the google image and I still have the problem. The power button also fails to activate the screen in recovery. But it allows me to select and enter recovery from the bootloader.
Any help would be greatly appreciated.
zetorung said:
I flashed francor 58 through the franco updater on top of mahdi rom 6/70. When I got boot loops I reflashed r57 (had previously worked) and when it came up I no longer had working volume rocker and power buttons. If I hold down power the device DOES power off. I tried flashing other roms as well as stock and the problem persists.
I did an e2fsck on data and a factory reset with the google image and I still have the problem. The power button also fails to activate the screen in recovery. But it allows me to select and enter recovery from the bootloader.
Any help would be greatly appreciated.
Click to expand...
Click to collapse
Did you ever find what the problem was? I'm having the same issue.
Help, same here...
I flashed yesterday latest LaboDJ's Linaro (62v2) over an older version and this morning my power and volume buttons aren't responding at all.
I flashed back system.img and boot.img from latest ota.zip but the problem persists.
Buttons are working fine in bootloader...
Did you guys try other kernel? I never heard this problem before. Try to clean flash any rom and see if it solves.
No luck, even flashed the whole L factory image...
as soon as my screen goes off, my only solution to bring it back alive is to keep power pressed 15s and let it reboot. Proof that the button press is somewhat registered in hardware I guess
Mosquito2001 said:
No luck, even flashed the whole L factory image...
as soon as my screen goes off, my only solution to bring it back alive is to keep power pressed 15s and let it reboot. Proof that the button press is somewhat registered in hardware I guess
Click to expand...
Click to collapse
Holding down the power button for 10-15 seconds is hard-coded to be a battery pull emulation, not affected by ROM nor kernel.
Did you try running the flash-all.bat? (backup to a PC first)
Do sensors work well?
ok, I'm not 100% sure how but got my buttons back
What I last did before they start working again was to boot into bootloader then recovery which was still default (open Robot with red triangle).
I kept volume up while pressing power as I've read on some post (hard reset?) and the phone rebooted to android with both volume and control buttons working.
Did I reset something extra or is it pure coincidence? Guess time will tell