A few months ago my gt i5801 got a weird problem, whenever battery was low and I receieved a call, as soon as I hang up the call the pop up (power off, reboot, silent, data on/off) which normally appears by pressing power button pop ups and the phone enters in a boot loop it won't go past the gt-i5801 logo untill I remove the battery and restart it. I thought it was problem with the kisadworkx rom so changed to purumod rom but still same problem. It was all fine till 1 aug 2014 when I got a call my phone got into infinite bootloop, I went to samsung and few local shops but they were unable to fix, then I searched over internet and found that it maybe the power button problem, and someone on the galaxy y forum wrote that repeatedly pressing power may boot up the phone and it worked for me but after few seconds again the pop up appeared and again same bootloop. And and nothing works even if I enter cwm it switches off after 1 or 2 seconds. only download mode stays and I can flash rom easily but it won't boot.
please help me figure out the problem, this is my regular mobile.
1.Download correct rom
2.Factory data reset
3.Download odin v4.252
4.run odin click "one package" select ops and rom tar file.
5.Go download mod connect phone pc show odin port no.
6.Reclick one package choose ops and rom file.
7.Click start wait a sec.
8.all done.
Related
Hello all,
Yesterday I installed Firefly 2.7 on my Canadian Samsung Captivate. Everything worked fine except that I could not receive calls (when I did I lost connection and it hung up right away without me having the time to do anything).
What I did tonight is I tried to reinstall the stock firmeware found somehwere in here. I followed the instructions which asked me to instal it using Odin3 v1.7 which I did. What happened though is that right after I clicked start button in Odin, the installation failed so I was left with an incomplete install.
I was stuck in download mode and could not do anything with my device and my phone would not reboot so I removed the battery. Now I can't boot my phone no matter what I do, I can't connect it to the computer either. I tried the button combination to go in download mode (remove the battery, wait, press vol+ and - and power, connect the phone to pc, put the battery back in, take my finger of the power button) and nothing. No matter what I do or try my phone is not doing anything. It is turned off and it stays that way.
Is my phone now a piece of garbage ? Any idea what I could do ?
Thx in advance ...
I have Galaxy ace
I wanted to switch to 2.3.3, so I downloaded the software ROM manager did flash. He asked me to pick and chose just Pelephone Pelephone, he wrote that he succeeded. After Flash went to Backup (backup), I clicked, boom turned off. I gave him a minute or two That's it.
BY THE WAY, you know what this Emergency MOD? Computer can recognize it is about this situation.
help?plzzzzzzzzzzzzzz
it seems that you tried to show some intelligence in flashing rom
who said you to flash with rom manager when the site clearly stated that you have to use odin to flash rom.
the only thing now you can try is putting you phone in download mode and flash with odin and follow the flash guide directions below-
1) Turn off your phone
2) Remove your SIM Card and SD Card
3) Extract previously downloaded firmware
4) Open ODIN 4.38 on your PC
5) Select from extracted archive: OPS, Boot, Phone, PDA, CSC (leave EFS and One Package empty)
Select OPS file : Cooper_v1.0.ops in his field.
Click BOOT button and select: APBOOT_S5830xxxxx_xxx...._user_low_true.tar.md5
Click Phone button and select: MODEM_S5830xxxxx_xxx...._REV03.tar.md5
Click PDA button and select: CODE_S5830xxxxx_xxx...._REV03_user_low_true.tar.md5
Click CSC button and select: CSC_S5830xxxxxx_xxx......_REV03_user_low_true.tar.md5
6) Connect your phone via USB into PC
7) When the screen is turned on hold POWER+VOLUME DOWN+HOME and wait until the phone enters the Download Mode
8) If ODIN detected and recognised your phone should light up the first square to the left side
9) Press "Start" button and wait, the process should take 5-10 minutes
10) If all goes well your phone should reboot automatically
11) Square should change the color to blue and display "PASS" it means that flashing process was successful and we have the newest firmware
12) Disconnect your phone
13) Turn off your phone
14) Insert your SIM Card and SD Card again
15) Turn on your phone
16) Now you have the newest firmware!
Hey dude
tnx for hlp,but he dont get into download mode and recovery mod.
he Not Responding for nothing.
when i try to turn it on,recovery mod.download mod, he wont boot.
sorry to say but i think you bricked or semi-bricked your ace...
i got more then less same problem..
just have my galaxy ace GT-S5830
needed restart.. try turn on again... only thing he did was buzzing and samsung came in the screen lightning on and off... but wasnt able to continue to normal android menu...
i try a restart now
in small yellow i see downloading.. hope it works..
else i bring it back to the shop.. phone is just 1!! day old
guddu2011 said:
sorry to say but i think you bricked or semi-bricked your ace...
Click to expand...
Click to collapse
How to solve bricked SGA?
try this.. remove ur phone battery memory card and sim card .
Reinsert battery but do not turn on phone.
Start odin
Select OPS file : Cooper_v1.0.ops in his field.
Click BOOT button and select: APBOOT_S5830xxxxx_xxx...._user_low_true.tar.md5
Click Phone button and select: MODEM_S5830xxxxx_xxx...._REV03.tar.md5
Click PDA button and select: CODE_S5830xxxxx_xxx...._REV03_user_low_true.tar.md 5
Click CSC button and select: CSC_S5830xxxxxx_xxx......_REV03_user_low_true.tar. md5
then connect your phone via usb and keep the volume down + power + home button pressed
this shud put ur phone in download mode
then click on Start button in ODIN and ur phone shud restart
alstonleo said:
try this.. remove ur phone battery memory card and sim card .
Reinsert battery but do not turn on phone.
Start odin
Select OPS file : Cooper_v1.0.ops in his field.
Click BOOT button and select: APBOOT_S5830xxxxx_xxx...._user_low_true.tar.md5
Click Phone button and select: MODEM_S5830xxxxx_xxx...._REV03.tar.md5
Click PDA button and select: CODE_S5830xxxxx_xxx...._REV03_user_low_true.tar.md 5
Click CSC button and select: CSC_S5830xxxxxx_xxx......_REV03_user_low_true.tar. md5
then connect your phone via usb and keep the volume down + power + home button pressed
this shud put ur phone in download mode
then click on Start button in ODIN and ur phone shud restart
Click to expand...
Click to collapse
Facing the same problem, the critical point the mobile does not respond to power up (either turning on, recovery mode or even download mode), any help please??? I got this mobile less than month now
Samsung Galaxy Ace Wont Boot!!
when i press the power button of my galaxy ace, baring in mind the battery has charge, the empty battery indicator comes up and then the phones turns off straight away. i have tried flashing different versions of android hoping it was a buggy firmware but no luck. this also happens when plugging the phone into an ac power supply. any help?????????
If you cannot access the download mode or the recovery mode then your phone is bricked. All what you can do is go to the service center and pull up a nice story about how it happened while you were sleeping. If you are lucky enough, you will get a replacement.
Btw WRONG THREAD. THERE IS A SEPARATE ONE FOR THE ACE.
TeamCooper Developer
TheMyth Developer
www.teamcooper.net
Galaxy ACE only displaying the word "Android"
Same problem here, only I use Ubuntu 12 and was wondering if there is a way of re-flashing using download mode and Ubunu?
Last night my G6 rebooted itself and now it is stuck in a fastboot loop. It keeps restarting itself when connected to charger or PC. Nothing happens when phone is disconnected from charger/pc. Only message on screen is "Keep pressing power key for 10 seconds to exit fastboot mode" but it doesnt help. Phone was stock and not rooted...
MLu75 said:
Last night my G6 rebooted itself and now it is stuck in a fastboot loop. It keeps restarting itself when connected to charger or PC. Nothing happens when phone is disconnected from charger/pc. Only message on screen is "Keep pressing power key for 10 seconds to exit fastboot mode" but it doesnt help. Phone was stock and not rooted...
Click to expand...
Click to collapse
did you try to flash the newest rom ?
By the way .... which G6 do you have ? (L11, u10 etc..)
In the title it says U10, thought that would be enough info
I never flashed/rooted a phone before so I didnt try anything so far...
edit: I tried the suggestion from this post: http://forum.xda-developers.com/showpost.php?p=59545669&postcount=4
1. redownload the rom file from official location. ( http://consumer.huawei.com/kh/suppor...h.htm?id=38361 )
It is the official for g6-l11 (-> dl a version for G^-u10 instead)
2. put the update.app into dload folder on your sd card (unpack from the zip)
3. shut down your phone
4. hold volume+ volume- and power button. When it start to boot release the power button, and hold both the volumes until the instalation starts
5. you will see that firmware flashing begin, wait for the end
Click to expand...
Click to collapse
It seems to work, I see the green android dude and text "updating from external storage" but the problem is the phone keeps restarting itself so it doesnt continue with the update... I suspect sometings wrong with the battery, short circuit maybe?
edit 2:
After giving up last night i tried the above procedure one more time this morning...and for some reason the installation continued. Phone has been up and running again since 8:30 this morning...
where can i get stock rom that can be flashed via sp flash tool? my huawei ascend g6-u10 is bricked after flashing b330. any solution for this?
my phone is dead but my pc can still recognize it
Hi, I have a Galaxy S4 I9500 and I'm using GEAR CM13
The ROM was working fine until a while ago, but now suddenly there's a bootloop. Last thing I remember doing was accidentally holding the power button a bit long (while trying to lock the phone) so the power off/reboot menu came up and and then I tried to exit from it, but the menu didn't go away and the phone entered into a boot loop
Now, the Samsung i9500 logo just keeps flashing every 5 seconds. I'm unable to enter into recovery mode. I can enter download mode but it just exits out of that after 5 seconds and starts flashing i9500 logo again. I read about a hack to remove battery as soon as I enter download mode and it worked. It stays on download mode now. ODIN recognizes the device. What can I do using ODIN to fix the bootloop? Is there any ODIN flashable zip? I'm on the latest [20160711] build. I have important data in my device. Please help me recover it
I know I can reflash stock ROM and from there, reflash GearCM13 but I do not want to lose data as much as possible. I'm trying for fixes which do not wipe my data partition. I will go ahead with the standard method if I do not find a fix to recover from bootloop without losing data.
Phone: J4+ (SM-J415F)
I wanted flash the stock ROM via Odin on pc and something went wrong (i don't know what) and now the phone shows "An error has occured while updating the device software. Use the emergency function in the Smart Switch PC software." I tried to go in the download mode but the phone "restarts" every 2 seconds when i connect it to the pc or the charger.The recovery didn't work either.
Note: The phone doesn't start even if it is not connected to the PC or to a charger.
I'm also stuck in this weird .non. bootloop
Hey, I had this problem before. The Battery maybe depleted during flashing. You have to find a way to charge it.
Try to boot into Odin warning screen or the IMEI screen, it's where the device won't reboot while your connected to a charger, then give it some time to charge until you have enough time to flash your stock ROM.
Its what I did xd, just watch out for overheating. Using a GN variant.
I solved it by holding all 3 buttons and plugging into USB, it did the whole rebooting thing as usual but I kept the buttons held for about 15/20 reboots and then it FINALLY went into download and I could flash stock rom. If important or not, I'd left it charging all night but showed no sign of life whilst it 'charged'
Something to Try!
The issue seems to be with the HOME CSC is corrupted on the latest version - Probably something by Samsung to outdo the Combo files being produced.
PLUG-IN THE PHONE to PC (NOT WALL), Press and hold POWER + VOL UP + VOL DOWN to BOOT the phone to the ODIN message screen (with the warning), not the Download Screen itself > in this Screen release all the buttons at the same time, if you do this right you should still be on that same screen. Then simply press the POWER once. This should show a Barcode IMEI Serial, etc (Then leave for 5-15 mins on USB Charge then quickly swap with a wall charger).
Then leave it to charge for normally phone charging time. Later PUT INTO ODIN MODE and retry.
I have done this 3 times on this device to make sure this is the correct way.
You might get away booting it to ODIN and trying to swap the power but unsure about that.
After this Go to GOOGLE Search on your laptop/pc > search for SAMFIRM > Put in the model and Download the Combination for J415FXXU5ASK1 and then in SAMFIRM software click Download ROM > Tick the Binary Nature box and then Flash the Combination file in the AP button of ODIN then the on that ROM go to Orange Calculator (IME) type in *#0808# on the next screen select the option with ADB and RM & DMT (normally the bottom) then select PDA on the next and then SAVE and RESET then flash the SAMSUNG ROM with the CSC, not the HOME!<< Just a NOTE! Not Responsible for bricked devices if you do this wrong! Advice only! :good: