today i received Brand new j700H/DS 5 pcs for language
after flashing with odin all of them are dead no power at all
not going to download mode and nothing appears in computer when i connect it with computer
the flash file i use its working and tested file
always i use same file never had such a problem
after these phones i flash other phone on same flash file just to test if files has problem or no but it was working fine
even not matter of downgrading because i flash a phone with a latest version the last version which was available in samemobile.com then i tried to downgrade its working fine so phones are not dead because of downgrading
my question how to check if the bootloader is damage and which box has support for j700H boot repair
please replay i need a quick solution
thanks
j700f/DD (make in india.Christmas Pack) Dead After Flash off is if I start guide
Have you found a solution?
Also have a dead J700H/DS
I flashed with J700H file though
---------- Post added at 06:40 AM ---------- Previous post was at 06:40 AM ----------
Have you found a solution?
Also have a dead J700H/DS
I flashed with J700H file though
j700f/dd dead
Hi.
I have a samsung j700f / DD dead after pass flash with odin
Computer does not recognize my mobile.
(How can I get your phone to connect my computer? When the computer does not recognize it?)
1. Is there any way that the computer can recognize my mobile?
2. Is the problem can be solved by software?
ⴰⵣⵓⵍ,
Take the battery off then put it on after each of the attempts below...
Well before doing anything else, try a combination of keys such as :
- Power button + Home Key + Vol Up
- Power button + Home Key + Vol Down
- Power button + Vol Up
- Power button + Vol Down
- Etc
If nothing appears, then try a combination of keys while plugging it at the same time to the PC, but before doing so check if anything got detected [ sudo tail -f /var/log/messages ] :
- Vol Down
- Vol Up
- Vol Up + Vol Down
- Home Key
- Home key + Vol Up
- Home key + Vol Down
Note : In some SoC's the preloader or the SoC bootloader sometimes pops up for a few seconds and disappears, which gives the time for the flash tool to establish a connection before the SoC bootloader closes the connection, in other cases it keeps popping in and out, so focus when plugging the cable.
Then report back to this thread.
CHAOS-THEORY said:
ⴰⵣⵓⵍ,
Take the battery off then put it on after each of the attempts below...
Well before doing anything else, try a combination of keys such as :
- Power button + Home Key + Vol Up
- Power button + Home Key + Vol Down
- Power button + Vol Up
- Power button + Vol Down
- Etc
If nothing appears, then try a combination of keys while plugging it at the same time to the PC, but before doing so check if anything got detected [ sudo tail -f /var/log/messages ] :
- Vol Down
- Vol Up
- Vol Up + Vol Down
- Home Key
- Home key + Vol Up
- Home key + Vol Down
Note : In some SoC's the preloader or the SoC bootloader sometimes pops up for a few seconds and disappears, which gives the time for the flash tool to establish a connection before the SoC bootloader closes the connection, in other cases it keeps popping in and out, so focus when plugging the cable.
Then report back to this thread.
Click to expand...
Click to collapse
==================================================================================================
Hi
I did the steps. But in any case, the computer did not recognize the phone.
Then
I repeated the process with the power supply, too.
The result was that:
1. When the power button is pressed. (amount of flow is equal to 0.12.)
2. Whenever USB cable to connect the phone. (amount of flow is equal to 0.12.)
3. In all other cases (amount of flow is equal to zero)
where is the problem from? Is there a way to enter into download mode
When no images (dead), and amount of flow is not suitable for phones.
I am also using USB jig, steps did. But did not alter.
I am waiting your reply friends.
Thanks.
ⴰⵣⵓⵍ,
I have mentioned that you need to take the battery off everytime you make an attempt, did you do that?
And what flow are you talking about, electrons? charges? current? what's that amperes?
I don't understand what you mean by power supply, i can't follow you, and what about the jig, i've read that samsung's uses a system to enable different modes depending on the amount of resistance between DP and DM of the usb, i really don't know about this, but give it a try.
Technically if you corrupted the SoC internal bootloader, the phone wont be able to perform anything, unless mainly using JTAG to reflash the internal flash memory region of the SoC [ system on chip ], am actually stuck at the same place with an MSM8625 SoC from Qualcomm, i couldn't find anything else to communicate with the SoC's main ARM chip except the JTAG pins, logically there isn't another way in here.
j200h dead after flash
CHAOS-THEORY said:
ⴰⵣⵓⵍ,
Take the battery off then put it on after each of the attempts below...
Well before doing anything else, try a combination of keys such as :
- Power button + Home Key + Vol Up
- Power button + Home Key + Vol Down
- Power button + Vol Up
- Power button + Vol Down
- Etc
If nothing appears, then try a combination of keys while plugging it at the same time to the PC, but before doing so check if anything got detected [ sudo tail -f /var/log/messages ] :
- Vol Down
- Vol Up
- Vol Up + Vol Down
- Home Key
- Home key + Vol Up
- Home key + Vol Down
Note : In some SoC's the preloader or the SoC bootloader sometimes pops up for a few seconds and disappears, which gives the time for the flash tool to establish a connection before the SoC bootloader closes the connection, in other cases it keeps popping in and out, so focus when plugging the cable.
Then report back to this thread.
Click to expand...
Click to collapse
hello sir my set is dead after flash then i did above method phone is detected when i pressed volume up + power button and connected to pc......... now how to repair it.........
Hello.
I have intex cloud x12. It is hang when I start it.
I'm trying for recovery mode but it is showing Android with red triengl.
At the time of red triengl I press power key or power+ vol up key there is no option found and remain as it is.
I have also tried vol up+vol dwn+ power key combination so many times but nothing happened.
My phone is not rooted yet.
Please help plllzzzz...
Hello,
a colleague of mine has a Smartisan Nut Pro (hopefully the sequence is the same as this Nut R1) and while the phone was on at a certain point it kind of crashed and the display just showed the Smartisan logo. Since then, no way to switch it off or reboot it. I've removed the back panel and detached the battery to actually switch it off, but when I try to boot it again it's still stuck on the Smartisan logo and it doesn't do anything. It's not recognised by either adb or fastboot.
I want to try to reboot in recovery mode to see if I can reset the phone or something, but I have no idea how to enter it. I've tried to the following key combinations, to no avail:
Vol down + power
Vol up + power
Vol down + home + power
Vol up + home + power
Vol up + vol down + power
In every case it just gets stuck at the logo. Any idea how to enter recovery mode?
....
Hi, I've been trying to flash TWRP to my phone in order to root and install some custom roms but there is a problem. I boot into download mode just fine no problems I connect my phone to my PC via USB cable and Odin recognizes my phone I untick auto reboot choose the correct TWRP file and start it and this is where it all fall aparts. My phone doesn't restart on it own, it just keeps staying on the downloading please don't turn off the target screen. I tried all the button combinations no luck phone doesn't restart. Only combination that works is volume down and power button but that just shut downs the phone. I really need some help here guys. Thanks in advance
after flashing TWRP, hold down volume (-) and power button, do not release until you start again... when you start, change volume (-) button to volume (+) for a few seconds and release... then start twrp
After flashing TWRP, disconnect cable, hold Volume DOWN and POWER button and once the screen is OFF, press and hold POWER + Vol UP + HOME.
Hello,can someone please urgently provide a method to reset an A53. The teen who's phone it is,has forgotten his password. They cannot get the phone to power off or reset itself. They have tried the reset button found by the sim tray and they have also tried holding in power and volume down and power with volume up together but no success. How do they get it to factory reset please?
To restart phone use vol down + Power 7 seconds
Imediatly insert USB cable connected in Pc and press vol down + vol up
Thank you,will forward this to them