Hello guys I have been struggling for the past week, my LG G2 phone has been rooted, I flash a custom recovery TWRP then I lunched to my stock rom I then tried to update my firmware to 4.4.2 kitkat the update was downloaded successfully, then it told me to reboot, so I did phone switched off then I was stuck on a boot loop but this time it was a boot loop with a error message on the left top corner. and then it would take be to a dim back screen. I searched the entire week to find a method to get me through the start screen and I found this -> NO Recovery mode, No download mode, after OTA on rooted LG G2 http://forum.xda-developers.com/showthread.php?t=2582142 I done exactly what it was showing, then my phone switched off and now it won't power up. Then I tried turning it on NOTHING phone does't show the LED charging lights, does't respond to the usb being plugged in can't do ANYTHING I am guessing the battery has died so now I don't know what to do, either contact LG or should I try getting a battery that is fully charged or even use a factory cable any ideas guys ?
Call LG support.
Sent from my g2 using Tapatalk
Related
My sister has a LG Optimus Thrive(P506) that was working great until yesterday. The phone refused to boot up and every time I plug it into my computer to charge it, it keeps showing the LG logo for 3-4 seconds then powering of for 1 sec then starting again. The phone isn't rooted or anything and it's currently locked to AT&T. Any suggestions what to do? It doesn't boot at all unless it's in a power source. Also, we aren't in the US so the phone has been on airplane mode for 5 months now. Another thing is that ADB doesn't seem to see the device even when connected. Please help!
I remember this happening to my phone when it was fairly new and unviolated... just damn forgot what I did to fix it. I knew I did a factory reset using some button-power combination. It's in the manual. I lost mine.
You could also try booting it without the sim card and sdcard inserted.
Sent from my LG-P500 using Tapatalk 2
The factory reset is activated by pressing power+down volume+home. That triggers the factory reset if u are on stock with no custom recovery.
Hey all , Look I've been looking around the forums looking and following solutions..
At first my P500 started to get no service.
Than the phone got really hot, Than left it on charge over-night because the battery was draining heaps !
(Found out the battery went dead. got a new battery etc)
Woke up , and my phone was repeatedly displaying the "LG" logo.
It'll idle on that for about 3 seconds, than restart and it'd come up again.
I cannot access recovery mode or any other mode, BUT only emergency mode.
I flashed the 10A firmware on my p500 , worked fine, than installed Facebook, Than it turned off again and is currently doing the same "LG LOGO"
thing.
I have tried and tried repeatedly to reflash the firmware again (USING KDZ)
Is there any hope i can get my phone up and running? thanks guys.
LayALAD said:
Hey all , Look I've been looking around the forums looking and following solutions..
At first my P500 started to get no service.
Than the phone got really hot, Than left it on charge over-night because the battery was draining heaps !
(Found out the battery went dead. got a new battery etc)
Woke up , and my phone was repeatedly displaying the "LG" logo.
It'll idle on that for about 3 seconds, than restart and it'd come up again.
I cannot access recovery mode or any other mode, BUT only emergency mode.
I flashed the 10A firmware on my p500 , worked fine, than installed Facebook, Than it turned off again and is currently doing the same "LG LOGO"
thing.
I have tried and tried repeatedly to reflash the firmware again (USING KDZ)
Is there any hope i can get my phone up and running? thanks guys.
Click to expand...
Click to collapse
Using KDZ is dangerous. Word of advice: NEVER EVER INTERRUPT THE FLASH OR TAJE OUT THE BATTERY. Use lgdmp if you have to reflash.
Sent from my LG-P690 using xda premium
Will i be able to flash it using "emergency mode" ?
edit: Flashed, But still constant "lg logo"
Nevermind that, Checked the ERASE EFS ALL Option, Phone is now charging and past the Lg logo !
But restarts sometimes, and constantly has the lg logo when i remove the usb cable.
LayALAD said:
Nevermind that, Checked the ERASE EFS ALL Option, Phone is now charging and past the Lg logo !
But restarts sometimes, and constantly has the lg logo when i remove the usb cable.
Click to expand...
Click to collapse
Are you able to boot your phone into system? Which ROM, kernel and baseband you are using?
rishabhgangwar said:
Are you able to boot your phone into system? Which ROM, kernel and baseband you are using?
Click to expand...
Click to collapse
The phone will not turn on without it plugged into power.
I turn on wifi.. Instant turn off.
I cannot get past the android logo now, leaving it on to charge over-night (charges fine)
It aint the battery (got 2)
The android sound plays than turns off,
Anything i should do before the next step?
I flashed the stock virgin mobile australia v20E firmware.
Kernel is 2.6.35.10-perf (managed to reflash it to boot it up again)
/bump.
Hello Everyone,
I have been trying to help my friend with his soft-bricked G3. He wasn't rooted and had never even played with flashing anything, it just stopped booting one day and would display the "LG Life's Good" boot screen for a few seconds before going black and then just repeating this endlessly. I was able to get into recovery and download mode so I used the tot method to flash back to stock after a hard reset just produced the same results.
When I flashed the stock firmware, everything appeared to work fine, it went through the MiniOS bootup and everything, said success, gave me the hard reset status screen so when it finished I pulled the battery as instructed and rebooted but the phone still has the same issue. I have tried to run factory reset through recovery now that I flashed the new firmware and it still does the same thing, just hangs at the boot screen for a few seconds before going black and then trying again, endlessly.
Has anyone encountered this before? Is it bricked?
Thanks.
The_mamba said:
Hello Everyone,
I have been trying to help my friend with his soft-bricked G3. He wasn't rooted and had never even played with flashing anything, it just stopped booting one day and would display the "LG Life's Good" boot screen for a few seconds before going black and then just repeating this endlessly. I was able to get into recovery and download mode so I used the tot method to flash back to stock after a hard reset just produced the same results.
When I flashed the stock firmware, everything appeared to work fine, it went through the MiniOS bootup and everything, said success, gave me the hard reset status screen so when it finished I pulled the battery as instructed and rebooted but the phone still has the same issue. I have tried to run factory reset through recovery now that I flashed the new firmware and it still does the same thing, just hangs at the boot screen for a few seconds before going black and then trying again, endlessly.
Has anyone encountered this before? Is it bricked?
Thanks.
Click to expand...
Click to collapse
Pretty common prob plug it in to the wall charge see if it boots sometimes it still wont but most of the time it will the battery quality on the g3 is crap they last at most a year with a few exceptions i would first order a battery.
Hey guys, I've got a Kyocera Brigadier and I decided to change the runtime from Dalvik to ART. Now the phone is stuck on loadscreen and I don't know how to fix it. The phone is rooted using the KingRoot app, but I don't know if that would help in any way.
Please help me guys!
Similar Issue
I am have a very similar issue, I also rooted my Brigadier with Kingroot and all went well. However, I attempted to flash the Xposed Framework onto it using Flashify. After doing such it got stuck in a bootloop, I was able to fix that problem by booting into fastboot mode and using fastboot to push stock firmware back onto my device. However now I have an even bigger problem where my phone boots up to the Powered by Android screen and then to the Kyocera screen, however instead of continuing to boot to the Verizon Wireless screen and then into the phone, it gets stuck at a black screen. I have tried waiting for hours and nothing at all happens, also I can no longer seem to boot into fastboot mode or in other words the Powered by Android screen with the little 1 in the top left corner of the screen. Fastboot nor ADB recognizes the device when plugged into my computer, as neither list anything when ran. Please help, I don't want to have to pay and end up sending my phone into Verizon to be unbricked.
Ornias Abezethibou said:
I am have a very similar issue, I also rooted my Brigadier with Kingroot and all went well. However, I attempted to flash the Xposed Framework onto it using Flashify. After doing such it got stuck in a bootloop, I was able to fix that problem by booting into fastboot mode and using fastboot to push stock firmware back onto my device. However now I have an even bigger problem where my phone boots up to the Powered by Android screen and then to the Kyocera screen, however instead of continuing to boot to the Verizon Wireless screen and then into the phone, it gets stuck at a black screen. I have tried waiting for hours and nothing at all happens, also I can no longer seem to boot into fastboot mode or in other words the Powered by Android screen with the little 1 in the top left corner of the screen. Fastboot nor ADB recognizes the device when plugged into my computer, as neither list anything when ran. Please help, I don't want to have to pay and end up sending my phone into Verizon to be unbricked.
Click to expand...
Click to collapse
I have the same problem. I bought a new a Brigadier that was on 4.4.2. I rooted with Kingroot ran update and now my phone will not boot past Kyocera screen. It goes black with the back light on. Did factory wipe and still nothing. I am shocked that KK has killed yet another phone of mine. I very much dislike KK ROM. What did you find out?
Hello
I am new to working on these phones so I apologize in advance if I don't properly state any processes or terms correctly.
I have a stock non modded Verizon LGG3 VS985 that experienced problems with WiFi and Bluetooth not working and significant battery drain. This happened right after a recent update to marshmallow. I tried cache clearing, safe mode, hard reset and nothing solved the problem. I decided I wanted to take the phone back to factory condition. I started with the LG flash tool that uses the .tot and a .dll. I ran the flash and when the program got to approx. 80%(at checking mini os phase of the flash) the phone began to reboot and only got as far as the LG logo and after about 2 min of the phone trying to reboot the flash program said fail, usb connect or something like that. At this point the phone will only start and go into a loop that includes the vibrate and the LG logo. and that will cycle until I believe the battery would die if allowed. I then found a link here at XDA (https://forum.xda-developers.com/verizon-lg-g3/general/guide-flash-to-stock-10b-kdz-method-t2928140) that uses the KDZ method, was well written and easy to follow. I ran it on the phone and it was going great. The flash program got to 88% and the phone went into the boot loop with the vib and LG logo . The flash program continued to run until it was complete while the phone was in the boot loop and it got to 100% and said that the software installed. I powered down the phone via battery removal and now when it tries to boot it vibes, shows the lg log and then the green android symbol shows for about 2 seconds and then it does it all over again. I have tried a hard reset and nothing changes. I appreciate any ideas any of you may have on what I can try to get this resolved. Thank you.
Thread closed
Reposted here
https://forum.xda-developers.com/lg-g3/help/verizon-lgg3-vs985-booting-t3550589