[Q] Question about the dock battery and wiping stats??? - Eee Pad Transformer Q&A, Help & Troubleshooting

I have a weird question about wiping battery stats. I know when you flash new roms on android, it's usually preferred to charge to 100% then go into cwm to wipe battery stats. Is there a way to do this to the dock as well? Would this even need to be done? Just wondering....

Don't bother wiping battery stats... it does absolutely nothing.

Related

Should I wipe battery stats after flashing a new kernel?

Title says it all
I always do and I also make sure phone is fully charge and plugged in. Cant hurt
wouldn't hurt, also if swapping batteries as well.
Question related to this - what is everyone's battery voltages when maxed out? I heard that 4200mV is normal, but after how much I charge it and wipe stats, I never get higher than 4080mV in spare parts.
Nikolai2.1 said:
Title says it all
Click to expand...
Click to collapse
Sorry for the noobness, but How do you wipe battery stats?
moosez3 said:
Sorry for the noobness, but How do you wipe battery stats?
Click to expand...
Click to collapse
rom manager, reboot into recovery or pull battery, and vol. down.
D3TH METAL said:
rom manager, reboot into recovery or pull battery, and vol. down.
Click to expand...
Click to collapse
Then go to advanced>wipe battery stats and remember to charge to 100% before wiping. Then let battery completely drain until phone dies and charge back up to 100% preferably with the phone still off.
thanks guys, and sorry i got back here so late. I also use an app from the market called battery calibration. I think its better because rebooting into CWM may use some battery and you would never know
I have another question.
What exactly is the battery stats? and what does it do when I wipe it?
I've been wiping the dalvik cache and battery stats when I flash rom/kernel/etc but never really knew what they were.
eccenpix said:
I have another question.
What exactly is the battery stats? and what does it do when I wipe it?
I've been wiping the dalvik cache and battery stats when I flash rom/kernel/etc but never really knew what they were.
Click to expand...
Click to collapse
Only flash battery stats when its charged to one hundred or it'll screw your battery readings. It just makes your battery meter more accurate because flashing a Rom screws with it.
Sent from my ADR6400L using XDA Premium App

Wiping battery stats...

Well now that I got temp-root I decided to wipe my battery stats because I got an extended battery.
When I reboot and lose root, will it revert back to the old battery stats? And when I re-temp root, will it have the new battery stats?
From my understanding, once the battery stats are gone, they're gone. I would assume that once you wipe them you will keep with whatever you currently have. There is an app in the market that will walk you through the process and do it for you.
durps said:
Well now that I got temp-root I decided to wipe my battery stats because I got an extended battery.
When I reboot and lose root, will it revert back to the old battery stats? And when I re-temp root, will it have the new battery stats?
Click to expand...
Click to collapse
Hi,
Wiping battery stats does not actually do anything
Look HERE

After unplugging, battery stayed at 100% for hours, recently installed cyanogenmod

My buddy recently rooted my phone, I don't know much about this stuff yet. I unplugged my phone and it stayed at 100% battery for like 6 hours. My buddy says we need to wipe battery stats.
Can anybody help me with this?
Thank you
Download battery calibration from the market. Its free and the easiest way to do it.
Sent from my HTC Thunderbolt
yes wipe your battery stats
I've had problems with aosp roms doing that. The battery percentage sticks, then when you reboot, it updates.
Not sure what the cause is, but wiping battery stats didn't help.
Thanks for the replies.
I'll try all three.
How would I go about wiping battery stats? Does the phone need to be charged to 100 before doing this? Please walk me through it as if I were a 4 year old.
Recovery/ advanced/ wipe batt stats/ reboot to recovery/ system reboot.
should battery be full/plugged in to full when this happens?
If I do this, should I avoid downloading the app mentioned above?
Kdeli said:
should battery be full/plugged in to full when this happens?
If I do this, should I avoid downloading the app mentioned above?
Click to expand...
Click to collapse
Charger should be unpluged , battery at 50% or above is ok , download the app after you are finished.
Kdeli said:
should battery be full/plugged in to full when this happens?
If I do this, should I avoid downloading the app mentioned above?
Click to expand...
Click to collapse
it is best to do a full charge.
have the app on your phone, clear stats
use phone until battery is fully dead, or close to it
recharge again to 100% with out unplugging it
and you should be good.
however charging it to 100% and wiping stats will be fine.
you can do it from the battery app mentioned above, or once charged to 100%, hold power, select reboot, choose recovery, once clockwork shows up, go to advanced, wipe battery stats, "go back" reboot phone.
Thank you all very much. It is much appreciated.
I look forward to actually doing some reading in my spare time (yea right, spare time,) so that I can be more educated.
-k.d.

Wiping battery stats

Is wiping battery stats still the same process?
Wait for battery to completely drain
Plug in phone/boot into recovery
Wipe battery stats, then power off
And let it get a full charge?
Sent from my iPhone 4S using Siri
I almost never wipe Battery Stats, only when i'm getting horrible battery.
But if you want to do it, just wait until it's charged and wipe battery stats using "Battery Calibration" App (Faster than going into CWR). Then simply go through at least one complete battery cycle.
There's never a fixed and confirmed way about doing this.
Some said to fully drain, then wipe battery stats (no clue how do you wipe something if it's already fully drained), give it a full charge (they didn't specify if the phone has to be on/off either).
And some others said it's best to fully charge, wipe, full discharge, and then a full charge again.
Some don't even recommend it at all, saying the battery stats will "fix itself" after a couple of discharges anyway, so calibrating won't be necessary.
cabstrak said:
There's never a fixed and confirmed way about doing this.
Some said to fully drain, then wipe battery stats (no clue how do you wipe something if it's already fully drained), give it a full charge (they didn't specify if the phone has to be on/off either).
And some others said it's best to fully charge, wipe, full discharge, and then a full charge again.
Some don't even recommend it at all, saying the battery stats will "fix itself" after a couple of discharges anyway, so calibrating won't be necessary.
Click to expand...
Click to collapse
i tell people both ways, either charge completly full or completly drain it. then delete the batterystats.bin file and reboot. generally i use root explorer to delete it. its located in /data/system/batterystats.bin. theres many ways to do it.. in recovery, with root explorer, with a battery calibration app, or with a script in the terminal emulator.

[Q] when calibrate battery?

have I got to calibrate battery everytime I update a rom or flash a zip?
or just when I change rom?
Only when changing the ROM, but it is not always necessary.
and, is necessary to reflash the bravia engine everytime I update my rom? or zips like that
If the ROM does not contain the Bravia Engine then yes. Look in the ROM's description for these informations.
Wiping battery stats have no effect. Just charge it to full and use it for a couple of cycles to calibrate it. No need to wipe the stats.
Sigg1996 said:
Wiping battery stats have no effect. Just charge it to full and use it for a couple of cycles to calibrate it. No need to wipe the stats.
Click to expand...
Click to collapse
Actually it has, for me after some modding arround with battery i charged my phone and it stuck at 99% and kept charging forever and i noticed a touch lag, i re calibrated and went to 100% with a green light showing its not charging anymore.

Categories

Resources