Just got my HDMI cable and found the first problem with my Transformer. Sure, I have some minor bleed but it's only noticeable if you're looking for it. This HDMI port, however, is definitely a problem. The cable seats well in the port but the port itself feels like there's some play between it and the chassis. I often have to jiggle the cable for the device to detect the connection and then it's often so touchy that the slightest shift will break it. And if I jiggle it just right I can cause an instant SOD on demand.
I had none of the other major issues folks have discussed but looks like I'm going to have to contact ASUS tomorrow anyway cause this is a definite hardware defect.
sent from a device using an app
Related
Just wondering if anyone else's usb cable is a little bit "shaky" after being plugged in? I guess it's normal since i don't have any poor contact issue so far, but ...it's kinda annoying..
Sorry if you didn't notice it before but you do now
ye my last android did that too. after using the micro usb port a few times it gets "shaky"-er haha
NIKEstickER said:
ye my last android did that too. after using the micro usb port a few times it gets "shaky"-er haha
Click to expand...
Click to collapse
ya all my phones with a micro usb port have eventually gotten this way...
futureaccount said:
Just wondering if anyone else's usb cable is a little bit "shaky" after being plugged in? I guess it's normal since i don't have any poor contact issue so far, but ...it's kinda annoying..
Sorry if you didn't notice it before but you do now
Click to expand...
Click to collapse
My Epic 4G Touch is the same exact way. However, I never had this issue with my Evo. Wonder if its an issue with the ports on Samsung phones.
I have found taking a pair of pliers and adding some slight pressure to the end of the usb cable has helped tighten things up. Make sure you are squeezing the entire connector and not using needle nose.
promiseofcake said:
I have found taking a pair of pliers and adding some slight pressure to the end of the usb cable has helped tighten things up. Make sure you are squeezing the entire connector and not using needle nose.
Click to expand...
Click to collapse
Its funny that you mention that because the looseness seems to be more dependent on the actual USB cable than the port itself (at least on this phone) Luckily, I haven't had any real connection problems with my phone. However, after replacing the cable, it seems to fit more snugly. Either way, its a little odd that it the same cable will seem more loose in this phone, but fit just fine in my previous one (still have it as a spare).
I've been having this problem lately also. Thinking in was a bug in the rom or a bad cable, the problem persists and its getting worse to the point it constantly will connect and disconnect repeatedly. I'm thinking its the phone because I've changed cables, usb ports and it still does it. But sometimes it will stick normally. Wierd...
If you have even tried brand new cables (since your existing ones may be worn out), then I would say that the port on the phone is likely damaged. Looks like it may be time for a service center repair.
My SR is the same way. The mini usb cocksoff to the right. I've experienced the same with a few Motos. I've came to the conclusion it is the cables themselves. I have noticed that the two teeth on the male plug get kind of wore out or not even pop back out and furthermore eventually damage the female port to where the phone will cycle from power to no power. I've especially seen this with OEM cables. I also saw a thread here where the guy gives an awesome, detailed breakdown of a screen replacement. The site he links has the replacement chip with the mini usb port if you feel froggy...
I just noticed that my charging port is extremely loose and any USB cable I stick in there has a lot of wiggle room. Because of this if I move my phone while charging it sometimes looses it's connection. I don't believe it ever did that before. Does anybody else notice a loose fit or is it just my phone?
Sent from my SM-N920V using Tapatalk
My charging port is pretty solid. But just to avoid this scenario, I got the samsung wireless fast charger pad
Sent from my SM-N920V using Tapatalk
Couple of things, if you have a case, try charging without it on. Otherwise try another cable. I thought mine was loose too but it ended up just being a cable that didn't fit well.
Thanks for the feedback guys. My case doesn't come into contact with the charging port or the cable when it's inserted. I use the original cable and a cheap chinese one intermittently. The Chinese one is quite long which is why I use it, but it wiggles much more than the original. I'm pretty sure there was no wiggle at all in the beginning so it must be from using the cheap cable. Note to self (and others): "Don't do that!"
Sent from my SM-N920V using Tapatalk
Hi there, I'm having the same issue. The thing is that I don't remember if it worked well from the start.
I always use an alternative charger and keep the original in the packaging.
One day noticed that at least 1/4 part of the plug remains out of the socket. This makes the plug wiggle and remain loose. Sometimes (a Tagwood cable) disconnects by the own weight.
I don't hear the common 'click' when plugging in or out.
Tried different cables, many including the original and every does the same.
I don't know if it is a design issue or a broken thing.
What I can see, I don't find any anomalies. Neither where is bottoming. It looks very sensitive parts so I don't want to touch it.
I only noticed that socket looks shorter than other micro USB plugs.
Sorry for my English.
If there's any suggestions I want to hear it.
hellcore said:
Hi there, I'm having the same issue. The thing is that I don't remember if it worked well from the start.
I always use an alternative charger and keep the original in the packaging.
One day noticed that at least 1/4 part of the plug remains out of the socket. This makes the plug wiggle and remain loose. Sometimes (a Tagwood cable) disconnects by the own weight.
I don't hear the common 'click' when plugging in or out.
Tried different cables, many including the original and every does the same.
I don't know if it is a design issue or a broken thing.
What I can see, I don't find any anomalies. Neither where is bottoming. It looks very sensitive parts so I don't want to touch it.
I only noticed that socket looks shorter than other micro USB plugs.
Sorry for my English.
If there's any suggestions I want to hear it.
Click to expand...
Click to collapse
Samsung phones have suffered from charging port issues for years. My Note 3 drove me crazy with it. You can try contacting Samsung, but I'm not sure what they would do.
Action123 said:
Samsung phones have suffered from charging port issues for years. My Note 3 drove me crazy with it. You can try contacting Samsung, but I'm not sure what they would do.
Click to expand...
Click to collapse
I had a Norte 3 and the plug was very strong and tighten.
Also 3.0 charged twice faster than other phones.
The phone is not buyed in my country. I can't contact Samsung
Guys, my brother had the exact same issue with his.
It ended up being lint that built up inside the port. Take a pin and clean the port out. I was shocked at how much lint (just from a normal pocket) got stuck in the port. Its definitely worth checking.
Worked for me!
CISGS said:
Guys, my brother had the exact same issue with his.
It ended up being lint that built up inside the port. Take a pin and clean the port out. I was shocked at how much lint (just from a normal pocket) got stuck in the port. Its definitely worth checking.
Click to expand...
Click to collapse
-------------------------------
At first my charging cable worked fine, but over time the connection became very touchy. Based on the post above, I opened up a paperclip and fished around the port area and was surprised by the lint that came out. Now my cable is connecting more securely and charging more reliably. Thanks for the tip!
I'm suffering from a very frustrating issue with my Moto X Play. I can live without the gyroscope, but this issue is getting a tad ridiculous.
The Play seems to very easily cause the retaining prongs on a micro-USB plug to become recessed. This problem isn't uncommon, and easily rectified with a pin, but it is frustratingly frequent.
I've misplaced my original Moto cable, but that was working fine for the weeks I had it. Since then I have tried a variety of free, cheap, branded and expensive cables and the issue occurs fairly consistently after plugging/unplugging a few times - I can only use them for one or two charges before they become unreliable.
Has anyone experienced this and can anyone suggest a solution? I wonder if the micro-USB socket is a tiny bit too narrow..
Hello XDA, here's something that has bugged me for a while.
I think everyone has experienced the tired out micro USB cable issue. You know, when the cable won't charge your device unless held at the proper angle, or when it won't even stay inside the device and just slips out. I believe this is caused by the little hook pins on the bottom of the plug getting a little bent or worn out.
This happens to me a lot. I operate heavy equipment all day and my phone is always bouncing around while charging. I think this bends the micro USB plug and I have to replace my micro USB cables like every couple months. Sometimes more.
So my question is, is this an issue with usb-c? I've searched online a lot and can't seem to find anything on it. This issue is a big deal to me since I'm pretty rough on my cables. Is it going to be a problem? Has anyone had this issue with a usb-c cable?
Thanks a ton everyone
,dratao
Sent from my LG-D852 using Tapatalk
troyhatchard said:
Hello XDA, here's something that has bugged me for a while.
I think everyone has experienced the tired out micro USB cable issue. You know, when the cable won't charge your device unless held at the proper angle, or when it won't even stay inside the device and just slips out. I believe this is caused by the little hook pins on the bottom of the plug getting a little bent or worn out.
This happens to me a lot. I operate heavy equipment all day and my phone is always bouncing around while charging. I think this bends the micro USB plug and I have to replace my micro USB cables like every couple months. Sometimes more.
So my question is, is this an issue with usb-c? I've searched online a lot and can't seem to find anything on it. This issue is a big deal to me since I'm pretty rough on my cables. Is it going to be a problem? Has anyone had this issue with a usb-c cable?
Thanks a ton everyone
,dratao
Sent from my LG-D852 using Tapatalk
Click to expand...
Click to collapse
I would like to also ping this thread as I am wondering the same thing. My last 2 phones required me to start angling the cables so that they would charge (likely based on the wear and tear of inserting and removing the cables).
So, is the design of USB-C more, less or the same reliability as micro-USB from a port longevity perspective?
Hi guys!
I'm a fresh Pixel 2 user (and for now, I love the device), but a very strange thing occurred to me. I unboxed the phone, connected the cables to transfer the data from my old Nexus, and everything went smoothly, the cable connected easily and firmly. When I came home and wanted to connect the charger I noticed I can't push the USB-C cable in - it was getting stuck before being pushed completely, and the phone wouldn't charge. I looked closely into the charging port thinking that maybe some small debris was locked inside, but instead I've seen a crooked metal brace (closeup photo attached, the part was really small) that seemed loose and was blocking the connector to go fully inside. I didn't know what it was, but I used a toothpick to try to lock it in place or at least see if it's really loose, but upon touching it simply came out from the port and hit the floor.
The port now works flawlessly, it charges, it connects to the computer, nothing seems lose, the cable sits tight, and it looks perfectly normal to me. I checked some other USB-C devices I have if they have similar metal thing inside, but none does. The port now looks like all other USB-C ports I've seen.
I wouldn't expect anything to come out of the charging port in a new phone though. Would you have any idea what's the purpose of this metal brace in the Pixel's port, and what could've happened that it got detached from the port? Should I be worried or just throw it into the bin and forget?
I'd appreciate any clues and insights
Thanks!
M.
This looks like half of the metal usb shield inside your port. If you look deep inside there should be another half (or maybe it's fallen out). The purpose of this part is purely to reduce electrical noise at the point of the connector, so you shouldn't really see any charging issues with it out, although you may run into the occasional data transfer issue.
Thanks, that's reassuring I don't really see the second half, but everything is working smoothly so I will not be too bothered then.
Keep the part. The phone is faulty. If you don't have problems, wait until the warranty is nearly out and then RMA the phone to get a 'new' one
This exact thing just happened to my Pixel 2 phone. I hope I don't have any problems. I know this is an old post. Did it ever cause you any problems?
maticomp said:
Hi guys!
I'm a fresh Pixel 2 user (and for now, I love the device), but a very strange thing occurred to me. I unboxed the phone, connected the cables to transfer the data from my old Nexus, and everything went smoothly, the cable connected easily and firmly. When I came home and wanted to connect the charger I noticed I can't push the USB-C cable in - it was getting stuck before being pushed completely, and the phone wouldn't charge. I looked closely into the charging port thinking that maybe some small debris was locked inside, but instead I've seen a crooked metal brace (closeup photo attached, the part was really small) that seemed loose and was blocking the connector to go fully inside. I didn't know what it was, but I used a toothpick to try to lock it in place or at least see if it's really loose, but upon touching it simply came out from the port and hit the floor.
The port now works flawlessly, it charges, it connects to the computer, nothing seems lose, the cable sits tight, and it looks perfectly normal to me. I checked some other USB-C devices I have if they have similar metal thing inside, but none does. The port now looks like all other USB-C ports I've seen.
I wouldn't expect anything to come out of the charging port in a new phone though. Would you have any idea what's the purpose of this metal brace in the Pixel's port, and what could've happened that it got detached from the port? Should I be worried or just throw it into the bin and forget?
I'd appreciate any clues and insights
Thanks!
M.
Click to expand...
Click to collapse
luisenriquereyes said:
This exact thing just happened to my Pixel 2 phone. I hope I don't have any problems. I know this is an old post. Did it ever cause you any problems?
Click to expand...
Click to collapse
No, everything was fine with the phone afterwards - at least for that reason. I had to RMA it for failing display though after few months of use, so I no longer have that particular one. With the replacement the metal brace is still intact.