Hi, I am using a Spectec wifi card to receive mails and navigate when i'm at home, and a data gprs connection outside. Since the wi-fi connection does't appear on the connections tab, is there a simple way to switch between them?
What i am doing now, is change the "work network" (which is configured for gprs) to "my isp", which is not configured at all, get a few connection error messages, and then the phone discoveres the wifi and connects to internet. But it's rather complicated and not ellegant at all.
Related
Hi all - i have my xda mini s setup to connect to the internet and collect my exchange emails all works fine.
i use it at work + at home a lot and both locations have a wifi broadband network.
i would like my xda mini s to only connect to GPRS for web browsing and emails when a stored wifi network is not in range (eg when im on the road)
Is it possible to enter in this preference anywhere? thanks in advance for any help
Actually, as far as PIE or any program that connects to the internet is concerned WiFi takes precedence over GPRS by default.
The problem is MS push mail. It forces GPRS even if WiFi is connected. If you try to serf to a graphics heavy site wile connected to both GPRS and WiFi you will see the speed difference.
I am not sure what the logic behind this MS stupidity is, and unfortunately I don't know of any cure except deleting the GPRS settings.
hi - and thanks.
damn.
well i did have a qucik test i went on the web and it seemed to be connecting to gprs (while i was already connected to a wifi network)
i will have a play.
There's one other thing I forgo to mention:
When connection to WiFi make sure you select the correct value under "This network connects to".
I assume your GPRS settings are under My ISP and that is what's selected in Settings->Connections->Connections->Advanced->Network selection.
You should then select "The internet" for the WiFi network.
hey, I have a problem with my HTC TP.
it always prefers the HSDPA link when connecting with a web based application souch as opera or MSN.
Even if I have it connected to a Wi-Fi it still boots up the HSDPA and goes online using that link.
I'm new to WM, so this is a bit vague, but I had the same problem, but I fixed it at some point last week...
There is a setting, somwhere (I told you it was a bit vague!), that tells programs to use WiFi as the default connection. I can't for the life of me remember where, and I've flashed roms since, but I'm sure it was a windows setting in "settings > Connections".
Sorry I couldn't be any more help, but at least you know there is a fix, somwhere...!
Hehe, thanks, I've tried looking for this feature for hours, becouse I can't for the love of whoever understand why there wouldn't be an option for it
there isn't one because it shouldn't need it. As long as your Wi-Fi is set to Internet, and Not work, it should always use that as long as it is connected.
Just having Wi-Fi turned on doesn't cut it.
There are certain applications that will always use the cellular network, like pushmail, but in general, all apps will use whichever internet connection is available. and if Wi-Fi isn;t connected, it will automatically connect to GPRS/3G.
Wellt hats the problem, I connected it t my home Wi-Fi set it as internet connection and the problem remains. I have redone the settings several times and it still prefers the HSDPA connection.
if I turn of all other alternatives to connect to the web, like removing APN settings for GPRS and HSDPA it uses the Wi-Fi, but as long as there is another Access link to the net the Wi-Fi isn't used
I have the same problem with Hotmail syncing (not defaulting to Wi-Fi), but not with Opera. I do have to change the connection settings though first from the T-Mobile Internet (and their magic transparent proxy) before Opera can work over Wi-Fi, but I thought the connection settings were just for HSDPA/GPRS connections. I'm finding this increasingly frustrating that I need to reconfigure everything depending where I am.
BTW, to get Hotmail to use Wi-Fi I have to go to the Comm Manager and turn off "Phone", turning off "Data Connection" doesn't work, because it craftily turns it back on, seconds later!
Hi there,
I have a question about an annoying problem that I've only managed to find one (unanswered) question to on the web.
I have an HTC Touch HD (WM6.1) which I use to read email from my Hotmail account, amongst other things. The problem is that the messaging client ALWAYS tries to download my mail via 3G/GPRS even when there's a WiFi connection available. This occurs both when I initiate the send/receive using TouchFlo 3D or from within the mail client.
Connection manager is, as far as I'm aware, configured correctly, and PIE/Opera/weather will all happily use WiFi to connect to the internet, only using my data connection when WiFi isn't available.
The same results occur with connection manager configured in either of the following ways:
Internet Connection = "My ISP" settings with 3G modem connection
Work Connection = Default "My Work Network" settings
WiFi Access Point = Connects to Internet
Network Card = Connects to Internet
OR
Internet Connection = "My Work Network" with 3G modem connection and "This network connects to the internet" enabled
Work Connection = As Internet Connection
WiFi Access Point = Connects to Work
Network Card = Connects to Work
Interestingly, if I disable my data connection and enable WiFi I CAN send/receive mail over the WiFi connection, so it seems like the data connection is being used in preference to the WiFi one.
Is this a known issue or am I doing something wrong?!
Thanks,
Mike
What´s the version of your ROM?
Is the device labeld by Vodafone?
There is an option when setting up the email account in pocket outlook to select the preferred connection for the account. It is in one of the advanced options pages when setting up the account. Normally it is setup for THE INTERNET so your WiFi adapter should point to the same.
Now, I use a little Mortscript to switch-on the WiFi and immediately change my Network Selection to NO DATA, which is just an empty setting (no internet connection). This effectively shutdowns the GPRS / 3G connection and pocket outlook has to use the WiFi route.
I have my gmail account linked for pull notifications...
the problem is it will not connect to gmail via wifi rather it olny updates through the 3g data network.
I have checked the advanced settings where the connection type is set to internet but this doesnt change things...
Any suggestions?
make sure you have the wifi connected on and connected to the internet.
also, through the connection tab in settings make sure you have told it that internet connects to wifi,
although, it may be better for you to temporarily disable the data connection whilst you use the wifi if the above doesnt work.
Im for sure connected to my wifi network...
I make the other adjustments...
thanks for the reply!
hi
sometimes wm can be picky like that
why not update over the 3g network?
This comes up becasue I work in the basement of a building with little to no access to cell signal so I can enable wifi and connect but it will not sync wia wifi...
Here's a basic question about the HTC Fuze. If I'm using the Edge network and I turn on wifi, thereby getting a faster connection, do Fuze applications default to the faster connection or do I somehow have to turn off the edge/3G connection specifically. I know I should be able to tell...
I usually have both wifi and edge/3g off. When I need data I turn on whatever i need. You do that thru the communication manager.
I think the real question is with both the Edge/3G on and Wifi connected, where will the data transfer? Through the cell network or the WiFi network?
the icons on the top bar of my device display clear which connection is active
with a data session
when one is active it's the only one being used to access data from the internet
It's possible to have both OTA and wifi active, which is what the OP is driving at. IME a program will find and use the faster connection at startup, but if the program is running on OTA and you connect wifi, a lot of programs won't switch to the faster connection. Again, that's just my anecdotal experience - it's hard to tell which connection is being used in real time.