SOS!
The Red Buttom is not available （during calling，if screen closed。 can not use red buttom to end the calling） even use MIC Fix.exe (R1 ROM)
Gratefully！can someone help me or give any suggestion and experience！
THX!
BRs
The same problem.
Red button
this is to make a note of problem observed so that experts like Xiaogin / Cotulla can help us.
Irrespective of the call when we press phone red buttion it gives a small beep and taks us to today screen,in R1 is is observed that only some times it responds and some times it does not! in O4 it is fine i think...
Please help
j_svas said:
this is to make a note of problem observed so that experts like Xiaogin / Cotulla can help us.
Irrespective of the call when we press phone red buttion it gives a small beep and taks us to today screen,in R1 is is observed that only some times it responds and some times it does not! in O4 it is fine i think...
Please help
Click to expand...
Click to collapse
Thank you very much!
Yes,I found it sometimes not worked correctly,will do a small update these days.
xiaojin1985 said:
Yes,I found it sometimes not worked correctly,will do a small update these days.
Click to expand...
Click to collapse
Hello，xiaojin
Nice to meet you here! How about your GuangZhu trip?
BRs
xiaojin1985 said:
Yes,I found it sometimes not worked correctly,will do a small update these days.
Click to expand...
Click to collapse
Thanks for acknowledging this Xiaojin, you are the only one who can fix this with small tweak .
Hope you are doing good at your new place? we miss you being online always helping us.
Related
Hi,
I just upgraded my ROM by my problem is when charging, it can't seem to charge the phone fully, the batt status is charging forever. I figure I have to hard reset my device but I don't know how.
Also, I want to know if there a handsfree mode for talking on the phone or do I need to install an appropriate software? THanks
well the manual should tell how to but
here is it anyway
http://forum.xda-developers.com/viewtopic.php?t=6023&highlight=hardreset
Re: How to hard reset AND Softwarehow to use phone hands-fre
pjfuerte said:
Also, I want to know if there a handsfree mode for talking on the phone or do I need to install an appropriate software? THanks
Click to expand...
Click to collapse
Try pressing, and holding it for 2 secs or so, the green call button during a call!! It will work..
Thanks for the reply.
j_metselaars: It doesn't work. It's the green handset button right? Not the one on screen. Can you help me? Thanks.
pjfuerte said:
Thanks for the reply.
j_metselaars: It doesn't work. It's the green handset button right? Not the one on screen. Can you help me? Thanks.
Click to expand...
Click to collapse
My XDA 2 has no problems with this. It is stated in the maual anyway! But during a phonecall, you press and hold the green hardware button!!! Just as long as it takes to give you a certain Icon in the start bar.... It states speakerphone enabled...
That workes on my XDA 2 and should also work on XDA 1!!!
Hi guys,
Have a TyTn II (Kaiser), am in Australia, on the 3 Network.
Been playing around and using Kaiser Kitchen have managed to burn myself a few ROMS and updated my phone.
However, I no longer have the option to make video calls.
So, is this a radio issue or dialer issue (or both) ? (or base ROM??)
And anyone from Oz (or elsewhere) suggest a good radio and/or dialer to use to regain video calling??
You can try this link. I tested on my 3. And it is working.
http://forum.xda-developers.com/showthread.php?t=503116
k, just found that one too.
Installed, works great...
Now, if only it was in black...
And is their a way of adding a video call button when ya call up a contact????
Moby58 said:
And anyone from Oz (or elsewhere) suggest a good radio and/or dialer to use to regain video calling??
Click to expand...
Click to collapse
I'm on 3 Australia as well and would also like to know radio recommendations
This might be of use.
Ive been experimenting with skinning dialers at the moment and have produced two betas.
Black and red and black and lime. They arent completly done yet, im fiddling with the registry to get the text while in the call to red so i can skin the buttons black...but they are 80% done.
http://forum.xda-developers.com/showthread.php?t=528132
adderz91 said:
This might be of use.
Ive been experimenting with skinning dialers at the moment and have produced two betas.
Black and red and black and lime. They arent completly done yet, im fiddling with the registry to get the text while in the call to red so i can skin the buttons black...but they are 80% done.
http://forum.xda-developers.com/showthread.php?t=528132
Click to expand...
Click to collapse
Nice one bro! Love the red one. Thinking of making a red ROM with this CommManager!
Hi Moby - Could you please let me know the Radio you're using? Thanks
spuri78 said:
Hi Moby - Could you please let me know the Radio you're using? Thanks
Click to expand...
Click to collapse
U r using ultimateX2? Wut videocall cab u using? got any problem?? Mine having graphics defects
pandyakavit said:
You can try this link. I tested on my 3. And it is working.
http://forum.xda-developers.com/showthread.php?t=503116
Click to expand...
Click to collapse
thats the one that works for me
johansons said:
U r using ultimateX2? Wut videocall cab u using? got any problem?? Mine having graphics defects
Click to expand...
Click to collapse
I'm using the one below as well and works splendidly for me
http://forum.xda-developers.com/showthread.php?t=503116
I have a problem that i have to use hand free to hear my mobile but when somebody call it start to ring and i hear it . the mic doesn`t work at all
please can anyone help.
Thanks
seriously non-informing post.
To establish what is wrong we need info because our crystal balls aren't working at this moment, sorry for the inconvenience caused by the malfunctioning crystal balls.
What device, which ROM which radio, when did it stop working. etc etc etc.
the-equinoxe said:
seriously non-informing post.
To establish what is wrong we need info because our crystal balls aren't working at this moment, sorry for the inconvenience caused by the malfunctioning crystal balls.
What device, which ROM which radio, when did it stop working. etc etc etc.
Click to expand...
Click to collapse
hey Eq, my balls are working just fine thanks, as to the question however, i have no idea.......OT i know, but couldnt resist ha
timmymarsh said:
hey Eq, my balls are working just fine thanks, as to the question however, i have no idea.......OT i know, but couldnt resist ha
Click to expand...
Click to collapse
The problem with crystal balls is that they break easily when you let others play with them
the-equinoxe said:
The problem with crystal balls is that they break easily when you let others play with them
Click to expand...
Click to collapse
Ha ha.... so true!! Ever wondered why guys dont cross their legs........?
Sorry......
hey
I`m v.sorry for my incomplete information
my device is :
T-Mobile MDA
Rom : 2.21.2.6 WWE
Radio : 02.19.11
doesn`t work a month ago (Telephone speakers work only when someone call i hear ring tone & to hear him i must use headset plus MICROPHONE doesn`t work at all ) i know its a complex problem but I count on you...
thanks u all.
theda said:
hey
I`m v.sorry for my incomplete information
my device is :
T-Mobile MDA
Rom : 2.21.2.6 WWE
Radio : 02.19.11
doesn`t work a month ago (Telephone speakers work only when someone call i hear ring tone & to hear him i must use headset plus MICROPHONE doesn`t work at all ) i know its a complex problem but I count on you...
thanks u all.
Click to expand...
Click to collapse
If the jack connector-contacts are dirty it sometimes happens that the device keeps hanging in handfree modus.
You can try the following:
-remove battery (!)
-spray a bit of contact spray into the headphone jack-connector of the device.
-plug and unplug the jackplug several times (cleaning the jackplug every few strokes with a tissue to remove any dirt and keep it away from the connector), and reapplying contact-spray when necessary.
-leave the device to dry for an hour or so (contact spray doesn't cause any short circuits, but I always leave it to dry before testing).
-plug in the battery, and test the device.
Regards,
EqX
Thanks
thank you EqX
i`ll try it and tell u ..
thanks again
Guys, when i put a JB ROM, when i make one call, the screen turns black, and the proximity sensor don't work. I only have this black screen, and i'm unable to use the keyboard and even hang up. Sometimes i have to press the power button until the phone turn off.
How to solve this ?
marioneri said:
Guys, when i put a JB ROM, when i make one call, the screen turns black, and the proximity sensor don't work. I only have this black screen, and i'm unable to use the keyboard and even hang up. Sometimes i have to press the power button until the phone turn off.
How to solve this ?
Click to expand...
Click to collapse
Sounds like this issue:
http://forum.xda-developers.com/showthread.php?t=2199788
THANK YOU!
Silellak said:
Sounds like this issue:
http://forum.xda-developers.com/showthread.php?t=2199788
Click to expand...
Click to collapse
Man.... Thank you very much! Worked very well!!!! Thank you again!
marioneri said:
Man.... Thank you very much! Worked very well!!!! Thank you again!
Click to expand...
Click to collapse
No problem! Glad it worked - I remember how frustrating it was when I stumbled across this issue myself.
Out of curiosity, did you end up using the same settings I used? Or did you have to use something different?
for me worked well in PS1 50 and PS2 60.
Hi,
I have just got a Huawei GR5 2017 (BLL-L22) phone. I'm trying to establish if this phone has LED notification (such as when receiving an email/Whatsapp/charging, etc). Looking at the specs of my phone it says there is LED notification and in the main settings menu>Notification & status bar there is an option for Pulse notification light (which is toggled to ON).
The problem is I can't see any sort of LED/light flashing or otherwise when i receive a message or email and there is no light when the phone is charging.
Can anyone help or clarify?
Thanks in advance
Strange, the led should work normally. Usually it becomes orange while it's under charge, green on calls/messages notifications... You could try apps who uses the led (like whatsapp, for example) to check if it's a software error or else. Did you recently updated the device, made something else that ended bad..?
RedSkull23 said:
Strange, the led should work normally. Usually it becomes orange while it's under charge, green on calls/messages notifications... You could try apps who uses the led (like whatsapp, for example) to check if it's a software error or else. Did you recently updated the device, made something else that ended bad..?
Click to expand...
Click to collapse
Thanks for taking the time to reply. I tried playing around in notification settings but have never seen any LED flash at all. I have looked at the front of the phone where the manual that came in the box indicates the LED is located, but I can't physically see anything. I also tried installing a light manager app (can't remember it's name), but everytime I tried to do the 'test' it said I may need to press the power button to put the phone on blank screen and then no flash.
I'm beginning to think that the GR5 2017 doesn't have an indicator LED (hence the reason for posting on here in hopes that someone with more knowledge of Huawei phones would be able to tell me one way or the other).
bump
bump
travelboyuk said:
I'm beginning to think that the GR5 2017 doesn't have an indicator LED (hence the reason for posting on here in hopes that someone with more knowledge of Huawei phones would be able to tell me one way or the other).
Click to expand...
Click to collapse
The led should be present standing by online reviews, but a confirmation from an user who owns one is what you need.
RedSkull23 said:
The led should be present standing by online reviews, but a confirmation from an user who owns one is what you need.
Click to expand...
Click to collapse
Thanks for taking the time to respond again Red. That is exactly what I was hoping for when I posted this. Don't suppose you are friendly with anyone here who owns one are you?
Thanks again.
travelboyuk said:
Thanks for taking the time to respond again Red. That is exactly what I was hoping for when I posted this. Don't suppose you are friendly with anyone here who owns one are you?
Thanks again.
Click to expand...
Click to collapse
Hey it's a forum, nothing hard to do boyuk unluckily i don't know anyone who owns a BLL-L22, but the bro @shashank1320 could know someone who owns/owned one before. What do you say pal?
RedSkull23 said:
Hey it's a forum, nothing hard to do boyuk unluckily i don't know anyone who owns a BLL-L22, but the bro @shashank1320 could know someone who owns/owned one before. What do you say pal?
Click to expand...
Click to collapse
Hey..if it is BLL-L22C636, it is Asia model in Taiwan. @sweetjuice to assist further as he owned the device and helped us with all info on this model.
shashank1320 said:
Hey..if it is BLL-L22C636, it is Asia model in Taiwan. @sweetjuice to assist further as he owned the device and helped us with all info on this model.
Click to expand...
Click to collapse
That's correct but in Thailand not Taiwan (though I presume they have the same 'Asia' version). I'll drop sweetjuice a message.
Thanks
travelboyuk said:
That's correct but in Thailand not Taiwan (though I presume they have the same 'Asia' version). I'll drop sweetjuice a message.
Thanks
Click to expand...
Click to collapse
Maybe you already got your ans, but I just bought the GR 5 '17, build # : BLL-L22C636B160,
I would like to Confirm : It has a Notification light.