Database Info

HS850 not compatible with WM6?

I have an HS850 that I have used on many other phones today to test and when trying to use it on my wizard which was running NBD 9.1 it failed to work. It is able to partner and everything however when i answer or make a call i cant hear anything or the person can not hear me. I tried flashing with TNT 5.0 and still have the same problem. Anyone have any idea what is causing it or how to fix it?

Same device, no problems
I have the same device, used it on all WM6 versions
(I'm an addict serial flasher)
it simply works, always (when u can get the BT to turn on, which was reported as an error is some roms).
Try checking your device, is it unlocked? did u flash to the original first?

Same problem
I've got the same issue with my hs850 and TNT rom. But I read that it's a common issue with official wm6 roms. The only way to make it works is to answer to the call on the phone and after that turn on the headset. I'm still loking for a fix.

problem with o2 life

Hello,guys
I meet some problems with my new ppc,ATOM LIFE
when i using ppc,i found i can't hang up and answer the phone.
i try to change new one sim card,but the problem also have.
i can send message but i cannt make a call
who can help me...thank you
I'm using WINDOWS MOBILE 6.0

i had similar problems in the very begining so luckily as i had no 3rd party s/w installed on it i had nothing to loose so i had reflashed my ppc with the official o2 wm6 ROM (also check the site o2service.c*m as there was an earlier version of the wm6 rom too which was upgraded there)
but now my ppc didn have those problems though a few hangups occur occasionally but then i'm able to pin point them to some new s/w i instal...!
hope this helps
TC

Windows Mobile 6.0

The signature shown is incorrect. That was the earlier ROM giving me problems...

Hi Everyone,
I have been writing on this same topic over and over again. Following is my problem:
I bought HTC Prophet/O2 Neo and it works well with Windows Mobile 5. I wanted to upgrade to Windows Mobile 6 and other higher versions. I can upgrade to WM 6 as well.
But following are the problems I face with WM6 and higher versions:
1) When I send a short message (SMS) to someone my phone works normally but if someone calls me the phone rings at their end but does not ring at my end. I switch off the phone (put it on standby) and then it works okay.
2) IF the phone loses the signal anywhere it just keeps on hunting for the signal. In the meantime it shows the green light blinking indicating it does have a signal. Now if in the meantime any one calls me up the phone again rings at their end but I do not get any incoming calls. I do not get any missed call alerts either.
I have reverted back to Jester's ROM in WM5.0 it is working fine again with the following problems:
1) The voice quality is not so great and calls regularly get dropped in areas where signal is not too strong
2) The contacts do not have options such as "File As"
3) When you want to dial and you put in the first few numbers for e.g. for dialling SAM you put in 726 it will display all entries related to 726. Though SAM is a part of these entries it should be the first entry as it is someone I call more often.
4) When you are playing music and put the phone on standby the music stops!
I request you to advise me on how should I upgrade to 6.0 or further in the best possible way or help me resolve the problems in WM5 with appropriate apps
Also one thing I wonder is what IPL/SPL/GSM should be there ideally for WM6.
Also FYI my friend has the same phone upgraded to WM 6.5 and it works perfectly for him. I put my SIM card in his phone and it worked fine as well.
Please help.
Regards,
Vinit Badani.

Hi Everyone,
I have been writing on this same topic over and over again. Following is my problem:
I bought HTC Prophet/O2 Neo and it works well with Windows Mobile 5. I wanted to upgrade to Windows Mobile 6 and other higher versions. I can upgrade to WM 6 as well.
But following are the problems I face with WM6 and higher versions:
1) When I send a short message (SMS) to someone my phone works normally but if someone calls me the phone rings at their end but does not ring at my end. I switch off the phone (put it on standby) and then it works okay.
-this might have to do with correct settings did you check your phone settings or if not did you hard reset after flashing a ROM whether is WM 5 or 6?
2) IF the phone loses the signal anywhere it just keeps on hunting for the signal. In the meantime it shows the green light blinking indicating it does have a signal. Now if in the meantime any one calls me up the phone again rings at their end but I do not get any incoming calls. I do not get any missed call alerts either.
-this doesnt happen to me maybe there is really a network problem or better yet check your phone settings again there might have been an appropriate setting for this situation
I have reverted back to Jester's ROM in WM5.0 it is working fine again with the following problems:
1) The voice quality is not so great and calls regularly get dropped in areas where signal is not too strong -that happens really if signal is not so strong better find a spot where in there is an appropriate signal
2) The contacts do not have options such as "File As" -this is ROM dependent i think... some ROM cookers incorporate these settings in their ROMS
3) When you want to dial and you put in the first few numbers for e.g. for dialling SAM you put in 726 it will display all entries related to 726. Though SAM is a part of these entries it should be the first entry as it is someone I call more often. -you have to live with it i guess since your using WM 5
4) When you are playing music and put the phone on standby the music stops!check your media player settings there is a setting that says play music even on standby mode
I request you to advise me on how should I upgrade to 6.0 or further in the best possible way or help me resolve the problems in WM5 with appropriate apps
Also one thing I wonder is what IPL/SPL/GSM should be there ideally for WM6.nope IPL doesnt matter SPL should be HardSPLed if your G3 you should have 2.G3.4PDA or G4 2.G4.4PDA (read more on how you will know if your device is G3 or G4 on Prophet WIKI THIS IS IMPORTANT BEFORE FLASHING ANY ROM GSM its only for getting phone signals etc etc and sometimes this matter when your battery drains so fast
Also FYI my friend has the same phone upgraded to WM 6.5 and it works perfectly for him. I put my SIM card in his phone and it worked fine as well.
Please help.
Regards,
Vinit Badani.

i am aware that my phone is a G4

Upgrade to 6.5 and Driver software in english
Dear Sir,
I have this Prophet mobile with Windows 5.0. My laptop has a windows Vista operating system.
I Need help to upgrade this system to WIndows 6.0/6.1 and also I request yo to guide me how to install this version in existing Phone.
Also I am facing a connection problem with my service provider Airtel. He says they donot have this phone in their list. They are unable to suggest manual settings.
Kindly reply me at [email protected]
Best regards
Dr. Suryakant Gupta

guptasuryakant said:
Dear Sir,
I have this Prophet mobile with Windows 5.0. My laptop has a windows Vista operating system.
I Need help to upgrade this system to WIndows 6.0/6.1 and also I request yo to guide me how to install this version in existing Phone.
Also I am facing a connection problem with my service provider Airtel. He says they donot have this phone in their list. They are unable to suggest manual settings.
Kindly reply me at [email protected]
Best regards
Dr. Suryakant Gupta
Click to expand...
Click to collapse
Dr. Gupta,
theres a wide range of infos regarding prophet upgrading on these pages
WIKI: http://wiki.xda-developers.com/index.php?pagename=HTC_Prophet
Useful Link: http://forum.xda-developers.com/showthread.php?t=350033
and also if your laptop has Vista platform and wishes to upgrade still here are good links too
http://forum.xda-developers.com/showthread.php?t=485293
http://forum.xda-developers.com/showthread.php?t=534707
feel free to ask if there will still be questions..
if you can also provide here your:
Phone Model:____________
IPL:____________________
SPL:____________________
Regards

[Q] Raphael unable to recieve/make calls but always shows connection !

Odd fault this (assume hardware) ! Just occurred with no recent software added.
Boot device or simply toggle radio off/on & it will work great but the following morning it will be unable to receive or make calls but carrier messages still work (GPRS account use ect)
Tried other SIMs & carriers & handset acts up the same.
Have tried quite a few radio versions & done a complete reflash of HardSPL Radio & New ROM but problem persists. Bit upset as handset is like new condition & I was happy with it :-(
Any ideas !
Anyone breaking a TouchPro !

whether your devices have invisible settings such as in SE Xperia ..?

[Q] [Bluetooth Question] Auto-Pairing -> Nokia CK-1W => Fails -> !0000

I 've spend lots of time searching (google and all) but could not find a answer:
I (actually my Wife) have a Nokia CK-1W Bluetooth Carkit (no remotes and stuff) In the earlier days (Donut) I managed to pair my Wife's HTC Magic with it at some stage with Cyanogenmod we battled with the same problem but around 5.x it worked and it was remebered over to 6.x (I don't have those roms (4.x,5.x) anymore so I can't see what the config was)
We both upgraded to Sensation but now we cannot pair with it (Nokia Ck-1W)
It seems the Phone want to pair with 0000 but the kit has a different number (last four digits of the serial number). Problem is it never gets asked for and fails.
I prosume the auto_pairing.conf file in the /etc/bluetooth folder should be able to resolve it. I tried putting in Nokia (after BMW,Audi,Parrot) without success.
I have S-OF,root& AdroidRevolutionHD, she does not (yet)
Anyone with some info, link or pointer that could help me out?
A solution that would work on Stock is prefereable, but we have S-OFF ...
Thanks
Tobie
HTC Sensation: S-OFF Android Revolution HD 1.1.6

In the mean while I've tried many different settings in the configuration without success (auto_pairing.conf and audio.conf)
I also found that the phone has a dynamic_auto_pairing.conf which seems to be copied over to the data folder once the ROM is running.
I'll try adding Nokia, Nokia CK-1W and 00:08:C6 modded into the ROM with a super wipe when AR HD 1.1.7 gets to us... ( :-( did not work...)
There also seems to be some database living with the bluetoothd files.. don't know how they work:-(

Any luck so far? I'm having a similar problem with my HD2 (BOYPPC CM7 SD build) and CITROEN C4 Picasso built-in bluetooth handsfree (I believe the make is Siemens). I was going to modify audio_pairing.conf, but if that fails for me, it would be great to know if you found another way around this.

Nothing yet Sorry!

I had the same problem. My HTC Magic (CM6.1) worked fine with the Nokia CK-1W, but when connecting my ZTE Blade (CM7.1) it told me that my passcode was invalid, without ever prompting me for a passcode.
The solution was simpler than I had thought: You just need to reset the CK-1W.
With the power off, press the button on the remote for about 15 secs until the light starts flashing. After about 10 secs the carkit will beep 2 times to signal that it has been reset.
If you have multiple phones, remember that the first phone you register will be the "default" phone (the phone the carkit will connect to automatically).