I can not turn my exec's irD (beam) off in WM 6.1.
However, i uncheak on "Receive all incoming beams"
Related
Hi have the I-Mate Jamin (after having O2 XDA II and XDAIIs previously).
I have reinstalled OziExplorerCE on the phone and bonded the BT GPS device. I noted on the Jamin I needed to create an outgoing port to get it to recognise the BT GP, I also created an incoming com port.
The only option for Comm ports were Incoming COM6, Outgoing Leadtek GPS COM7. It seems a bit strange but who knows..
When I go into OziExplorerCE configuration to setup the COM port I cannot select COM6 or COM7.
Any ideas. I have not had this issue previously.
Many thanks.
I use Widcomm stack on my notebook and WM 6.0 build 5.2.318 on Qtek 9100
When headset profiles is active - automatic pickup. With WM 5.0 I have choose to confirm or drop the call. Is any chance to return this behavior on WM 6.0?
Does anyone know if it is possible to change the bt stack used in 6.1 back to the 6.0 one without downgrading to wm 6.0.
I have some strange problems with 6.1 and my bt car kit. With normal 6.1 stack my kaiser crashed after calling over bt. With 6.1 and jetware kaiser doesn't crash but I can't make outgoing calls over bt device.
With 6.0 I had none of these probs.
Hi,
I do have the same experience with my Vario 3 running WM 6.1 and the VW Premium Carkit which uses the rSap protocol...
Any solutions in the meantime with WM 6.1??
regards from berlin
I installed Profiles for Windows mobile on WM 6.0 and it worked well, then I upgraded my Cruise to WM 6.1, I reinstalled Profiles, but now I have a problem: when I change the profile from a single bip to normal mode, the sms tone doesn't change. Any suggestion?
Does anyone know the setting that turns off the beep when wifi auto connects/disconnects?
I am using Rose 0.4 (WM 6.1)
Thanks, Chris