Redmi 9/9 Active (India) (Cattail) in brick state. How to cure? - General Questions and Answers

Redmi 9 / 9 Active (India) (Cattail).
The firmware was incorrectly produced. The device is in bootloop mode with the ability to access fastboot.
To restore, I used all Cattail firmware from 1 to 13.
When trying to flash TWRP, bootloop is removed only through Python or SPFT.

Related

Bluetooth problem

Once I factory reset my honor 8 ,Bluetooth ,screen record and few system apps are missing ,and I have a firmware zip (android7.0) for honor 8 can I flash it?
Device : Honor 8 FRD-L09
Bootloader: Unlocked
Recovery : Official
Boot.img fficial

[GUIDE][FLASH] How to keep flashing without AUTH or EDL on V12.0.5.0 or higher MIUI versions in MERLIN ? (Xiaomi Redmi 10X 4G / Xiaomi Redmi Note 9)

Works with:
- Xiaomi Redmi 10X 4G
- Xiaomi Redmi Note 9
If you try to flash in EDL mode, it will requires an authentication.
If you want to use flash tool on MIUI V12.0.5.0 or higher versions, you need to flash the stock rom preloader using V12.0.4.0 (or lower).
It will works perfectly with lower preloader binary version.
With an older preloader version, your phone will can receive DA files and accept flashing.
For flashing, you need to turn off and plug your phone in usb without pressing any key.
If you press any key, it will enter in EDL mode and requests authentication.
PRELOADER binaries:
https://forum.xda-developers.com/t/...omi-redmi-10x-4g-xiaomi-redmi-note-9.4221081/
DA files for flash tool:
https://forum.xda-developers.com/t/...omi-redmi-10x-4g-xiaomi-redmi-note-9.4209767/
Good luck
#NoAuth #NoAuthentication #No-Auth #No-Authentication
Do you need help with your MERLIN device ?
Read this FAQ: https://forum.xda-developers.com/t/...for-merlin-redmi-10x-4g-redmi-note-9.4225177/

Redmi note 8

Hi all i have redmi note 8 with global rom and i want to flash Indonesian rom cause it have xiaomi dialler
I did bootloader opened and installed twrp recovery is the recovery method will work or do i need to flash the rom through fastboot method because i searched the internet and found only the fast boot method
My rom 12. 0.5
Indonesia rom 12.0.2

Unable to re-lock device after going to stock. ERROR: "The system has been destroyed" when attempting to lock

Hi,
I have a Redmi Note 7 Pro (64GB/Indian Variant). I'm going to sell the device and it was running CandyOS (AOSP). In order to reset to stock, here's what I did:
Wiped everything using TWRP
Downloaded the latest MIUI (India (IN) MIUI 12.5 V12.5.1.0.QFHINXM) from this link
Ran the flash_all_lock script
When I reboot, I get the error: "The system has been destroyed". After unlocking with MiUnlock Tool, I can get back to fastboot and install custom recovery again and the stock MIUI 12 ROM boots up normally.
How do I lock the bootloader properly?

Redmi 9A does not power on after flashing NusantaraOS Android 12 Official

I just flashed NusantaraOS Android 12L on my Redmi 9A, but now it doesn't power on, I did everything okay but I don't know what went wrong, some people say it's the preloader but I don't know. Help me to revive and flash this rom.
can you boot into recovery or fastboot mode?
same redmi 9a not working and not charging after flash NusantaraOS Android 12L

Categories

Resources