The J7 prime I was using suddenly stopped working while I was running some searches on Google Assistant. It did not overheat, no root/kernel level modifications were installed. Was running stock sammy 6.0.1 rom and wasn't rooted.
I've tried to boot it to recovery/dfu , tried every volume+home+pwr button combo. But it just won't do anything. Help please?
Better late than never
Hi,
You're probably solved this by now - but I just had the same issue. Nothing else I tried worked before this:
While on charge (it won't say that it is charging or anything) hold Home Button + Power button for 30sec then wait a minute or 2.
After that press Volume Down + Home Button + Power Button for a few seconds.
After a few seconds I got a turquise screen warning me about a custom OS install.
I cancelled that with a Volume Down press and then my phone booted normally.
Hope it helps
Related
Hello everybody,
I have an annoying problem, I am running seans jelly bean 4.0t Rom with the latest update. My issue is when I press my power button once from an off screen state, the screen turns on, shows the power down menu, and then the screen goes black and I get the phone vibrating at every two second intervals. I can do a hard reboot from this point by holding the power button down for ten seconds and the phone will reboot. I have worked around this issue by using the wake screen with volume button feature, but I would like to be able to use my power button again. It does this problem everytime I press it once, it even does it after a clean flash with wiping everything 3x. Has anyone run into this issue before? I have searched for a problem like this, but haven't found any like this. Any help would be greatly appreciated! Thanks in advanced
I recently rooted my new Gooapple V5-3g. Everything was going fine and I was starting to download apps from Google Play, add contacts, etc. I was listening to the fm radio today and turned the volume down, then tried to turn it back up. It would not respond when I used the volume + button, so I tried to reboot. I powered down, then held the power button to power back up. Although I did not hold the volume + button while I was pressing the power button, it went straight into Recovery mode. Every time I reboot, it goes straight back to Recovery. If I power off, then back on again, straight to Recovery mode. I accidentally went into factory mode (trying every combination of buttons to override my 'stuck' volume + button) and did a Key Test...VlmUp was the only key that failed.
Would this be most likely to indicate a hardware problem? Or is there something that I could have done to cause this (by rooting)? And does anyone have the slightest clue if there is something I could do to fix it?
I bought the phone from Android-sale about a month ago. The only problem I noticed when I first started playing with it was that auto-rotate would not work in text-mode (tried setting it every-which-way in both settings and the android pull-down menu, to no avail. It works in everything else. Other than that, the volume button/Recovery mode is my first issue.
Any and all advise is greatly appreciated!
stucked in factory mode
I am stucked in this "Factory Mode" with these options available...
full test
item test
test report
clear flash
version
reboot
Please advise me what to do..... is it bricked......? i felt so helpless.
see picture. It doesn't recognise any rom at all.
Hello,
Hopefully I'm in the right place for posting something that seems to be this simple. The start of my problem is that the tablet will not stay off. When I try to shut it down, it shuts down normally, but then it starts to display the battery icons like it is plugged in and charging, but it is not connected to power. I can leave it in sleep mode and the charging thing will not happen, but turning it off displays the power charging screen and it further drains the battery. I figured something is screwy with the system so I would try to reset it to factory defaults. Now I have the other problem...
So I am trying to restore to factory defaults and I know to do this I have to start from off and hold down the up volume and the power button for a few seconds and as soon as the tablet starts to turn on release the power button but not the volume up button, and it should get me into the recovery/download screen. Unfortunately that is not working. I hold down the Volume up button and briefly hold the power button (3 or 4 sec or so) and I see the Samsung Galaxy Tab 2 7.0 startup screen and let go of the power button (still holding the Volume up button). Next I see the spinning blue circle around the Samsung logo and the tablet reboots. I can release the volume up button at any time after that and the results are the same, it just reboots. It's like it isn't seeing the volume button.
I have tried using the volume Down button instead of the volume up button but that too is just like I am not pushing any volume button at all. Once the tablet is on, the volume buttons function normally, so the switches are good.
Since I got this tablet used could someone have loaded something onto it preventing it from being rebooted into recovery/download mode? Maybe some custom firmware or something. I'm at a loss as to where to go next. Since I can't boot into recovery/download mode I can't get into Odin.
Any help is appreciated.
Rick
Hi. The tablet isn't rooted, is it? Can you try to boot it into download or recovery with the "quick boot" app from google play?
I don't think it is rooted, but I can't tell for sure since I can't connect to the Google play store. I tried downloading using the web browser, but my battery dies before if finished. I'll try swapping batteries and see what I can figure out. Thanks for the idea.
Rick
No, the device is not rooted. it also is not charging and I had a heck of a time getting it to connect to the play store. I think I need to try and reload the OS, but without being able to get into ODIN, or reboot into recovery, I'm not sure how to proceed. any suggestions?
When the battery thing appears do the power- volume up thing and hold it until the gtab logo appears.
I've tried that, and it just boots up as if I wasn't holding the volume button at all. Once the tab is booted, the volume buttons work as normal. I've even tried putting a different power/Volume/IR unit in (from a working tab with a broken screen) and that didn't make a difference.
I left the tablet all weekend and it just keeps showing that it is charging when not plugged in. By Monday the battery was 100% dead. It won't even charge. If I replace the battery with a battery from a working unit I'b back in the same place where I can't get it to boot to Recovery/download.
The problem started when I was on my bootloader that simply said "Downloading Do Not Turn Off Target" and I held the power button down to reboot since I didn't see any other way to cancel that screen. From then on, my phone kept restarting over and over again. Basically, it shows the "Samsung Galaxy S7 Edge" logo then turns off and shows a blank screen for two seconds then turns on again repeatedly. If I hold the power button, volume up and home button or just volume up and home button, the phone states "Installing system update" on the screen and goes to the menu that allows me to reboot the phone, clear cache, shut down, factory reset and so on. I tried factory resetting and clearing cache over and over again with no luck. I tried to install custom firmware by holding volume down, power button and home button and going into the bootloader and using odin but still no luck. Every guide suggested that the phone has a stuck power button but the tap methods don't work and I'd like to confirm that's the problem before I take my phone apart to replace that power button.
The thing that confuses me is that when I go into the menu with the options for rebooting, clearing cache, etc. the power button works fine. Whenever I want to shut down the phone, I can click the volume up and select the "Shut Down" option and then clicking the power button to confirm and it does shut off the phone. How would the power button be the issue if it works fine afterwards?
So would the conclusion be to replace the power button flex or is it a software issue? Or is my phone bricked after having it for three months?
(The problem's lasted for two days now)
Sorry, wrong thread.
-Jamie M.
AlexAquila00 said:
The problem started when I was on my bootloader that simply said "Downloading Do Not Turn Off Target" and I held the power button down to reboot since I didn't see any other way to cancel that screen. From then on, my phone kept restarting over and over again. Basically, it shows the "Samsung Galaxy S7 Edge" logo then turns off and shows a blank screen for two seconds then turns on again repeatedly. If I hold the power button, volume up and home button or just volume up and home button, the phone states "Installing system update" on the screen and goes to the menu that allows me to reboot the phone, clear cache, shut down, factory reset and so on. I tried factory resetting and clearing cache over and over again with no luck. I tried to install custom firmware by holding volume down, power button and home button and going into the bootloader and using odin but still no luck. Every guide suggested that the phone has a stuck power button but the tap methods don't work and I'd like to confirm that's the problem before I take my phone apart to replace that power button.
The thing that confuses me is that when I go into the menu with the options for rebooting, clearing cache, etc. the power button works fine. Whenever I want to shut down the phone, I can click the volume up and select the "Shut Down" option and then clicking the power button to confirm and it does shut off the phone. How would the power button be the issue if it works fine afterwards?
So would the conclusion be to replace the power button flex or is it a software issue? Or is my phone bricked after having it for three months?
(The problem's lasted for two days now)
Click to expand...
Click to collapse
Have you tried flashing the STOCK firmware via Odin or SmartSwitch?
I DO NOT PROVIDE HELP IN PM, KEEP IT IN THE THREADS WHERE EVERYONE CAN SHARE
Droidriven said:
Have you tried flashing the STOCK firmware via Odin or SmartSwitch?
I DO NOT PROVIDE HELP IN PM, KEEP IT IN THE THREADS WHERE EVERYONE CAN SHARE
Click to expand...
Click to collapse
Yea, stock firmware should do it. If you can get into recovery it's definitely not your power button.
Hi, I was trying to root my tab using Brk's Toolkit 8.0
But first, I had to go in APX mod. So I truned the pad off, pressed "Vol up" + "Start" but the tab just booted normally. I did it like 3 times and it always did the same thing.
So I figured I could test holding "Vol. Down" instead of "Vol. Up" while the tab was not booted but plugged to my PC.
The screen flashed, but the tablet didn't start. Instead, it turned black then showed the charging logo.
I tried again. Same flash. But this time the screen went black and nothing responds now. The screen is forever black.
How could this happen ? I know a device can turn into a brick after installing a ROM, but I didn't installed it yet...
Thanks for your insight
EDIT : Okay I feel super dumb but to be honest I didn't find this information elsewhere on the internet so I'm gonna share it :
After contacting Asus' support, they told me to maintain the POWER button for approx. 30 sec, then charging the device again.
Hope this could help someone