Verizon Galaxy S6 on freshly installed odin 7.0.1 keeps rebooting - Verizon Samsung Galaxy S6

Hi all! I recently purchased a verizon galaxy s6 that wouldn't boot past the verizon logo. Long story short, I got it working by flashing the AP through Odin for 7.0.1, but during setup, regular use, and sometimes no use, the phone will randomly either turn off or reboot. I've tried updating all apps, factory resetting, wiping cache, and reflashing through odin but I got the same outcome. Any help would be appreciated! Like I said, everything else is working fine, but every few minutes the phone freezes or goes black, and then reboots or just stays powered off.
Thanks for the help in advance!

Related

[Q] Samsung Logo Stuck - Advice Needed

Samsung Galaxy S5 G900A (AT&T)
Previously on a day off I became very bored, and decided to root my phone. After playing around with everything for a day i did not like it. So i just went into recovery mode and did factory rest on my phone. Now I used supersu and a basic root everything worked perfect after i rooted it. But once I tried to put the stock firmware back on my phone it started acting funny. With showing Unfortunately Context Service has stopped. It was so absurd my phone couldnt function properly. I tried flashing the stock firmware on there in hopes that it would fix my problem, but it only made my phone completely inoperable. I have been trying multiple ways to fix this using odin v3.09 and odin v 3.10.6. Here are some of the files I have tried to get my phone back to stock. (G900AUCU1ANCE_G900AATT1ANCE_G900AUCU1ANCE_HOME.tar.md5) I have tried downgrades. Odin seems to fail on every single one besides this set up (AP_G900AUCU1ANCE_964333_REV00_user_low_ship_MULTI_CERT.tar.md5) (CP_G900AUCU1ANCE_964333_REV00_user_low_ship_MULTI_CERT.tar.md5) (CSC_ATT_G900AATT1ANCE_964333_REV00_user_low_ship_MULTI_CERT.tar.md5) Odin loads those three files onto my phone perfectly with in 3 minutes but after they are installed on my phone. When i power it up it gets through the first screen and only shows half of the samsung logo freezes and goes to a black screen with a blue light. I have been working at this problem for a little over a week a couple hours a night and i really can not seem to make any progess. Help would be greatly appreciated.
Still having troubles
Flashes firmware perfectly fine but still can not seem to get past the samsung logo loading super slow and then just cutting out and going to a black screen with a blue stationary light on top left of phone.
Still looking for advice
bump
ksutinen said:
Flashes firmware perfectly fine but still can not seem to get past the samsung logo loading super slow and then just cutting out and going to a black screen with a blue stationary light on top left of phone.
Still looking for advice
bump
Click to expand...
Click to collapse
Boot into recovery mode and do full wipes wipe cache ,wipe del Vick cache,factory reset
I think this will resolve your problem
Regards
Mohamed786

G920F keeps bootlooping in a strange manner

Hello everyone, I've got a S6 G920F, that I tried to do everything to. Here's the problem and what I did:
First off the phone never turned on unless I put it in the charger and it would display the "emergency mode" screen. I switched to download mode while its attached to the computer, tried to flash stock firmware with no luck, until I found a PIT file that I flashed via odin and revived the phone that it got me the "Samsung" logo. But still it would turn off. I did efs repair and phone stopped turning off but still was stuck on samsung logo. I then came across this "choimobile" 4 file firmware and flashed only BL and AP(as they said) and phone finally turned on, started optimizing apps, finished and entered the system, I went to check if IMEI is intact from settings, and it suddenly rebooted, to system again, except this time for few seconds and reboot, then it got stuck on bootloop on the "samsung". I've been stuck here with nothing left to do.
Here are the links I used:
http://forum.xda-developers.com/galaxy-s6/help/sm-g920f-stuck-samsung-logo-5-1-1-update-t3150727
http://forum.xda-developers.com/galaxy-s6/general/g920f-pit-file-banded-firmwares-t3118459
Would appreciate any help thanks in advance.
P.S. I did wipe data and cache using recovery numerous times

Galaxy s6 G920v stuck in bootloop, have tried everything

Hi guys, so recently I bought a Galaxy S6 Verizon off of eBay. I got it for fairly cheap because it was stuck in a boot loop. I usually have no problem fixing stuff like this, but this time is different. So the first thing I tried when I got the phone was to do a reset and cache wipe from recovery. I rebooted the phone and it showed a screen that said "Android is starting, optimizing app 9 out of 31." when it got to 21 the phone rebooted and went back to 9. It did this several times before I attempted to wipe/reset again. I then downloaded the tar file G920VVRU4CPH1 and flashed it in Odin. I did a manual reset before the phone booted, and it is doing the same thing again. reboots to a green screen where it tries to optimize apps, stays there for about 20 seconds, and reboots over and over again in the same cycle. I have tried all other stock marshmallow roms that i can find, Odin won't flash older ones, (assuming its not letting me downgrade). Also another weird thing, every time I flash, the blue update screen goes to 32%, stops, erases, and reboots. Phone is on 6.0.1 version MMB29K.G920VVRU4CPH1 as seen in recovery. Any help would be gladly appreciated. Thank you!
I am having a similar problem with loading new rom. The farthest it gets is 32%. Sometimes it doesn't get even that far.
I ended up just buying a trashed s6 and swapping the motherboards. Only way I could fix it

Is my note edge 915A bricked? and if so can anyone help!

I was having trouble with random lock ups and reboots so i wanted to flash my 915A to another version of firmware that i had installed before. I used odin and it updated successfully. I then wiped cache and then did a wipe data/factory reset and then a
reboot. And then the samsung logo and then the AT&T logo and then nothing, The logo stays on for ever. The blue led is on and
dims in and out and thats all. I have left it for over a hour and nothing. SO i reflashed a few other firmwares that i have saved and have used all of them in the past and they all load via odin just like they should. I follow the same steps i have always used and
everytime it hangs on the AT&T logo? I have tried pulling out the SD card, I have tried with and without the SIM card and still
the same? IS my 7 month old phone bricked? PLEASE help me i really want and need my phone back. Does anyone have any ideas
on what i can do or try? Thank you for reading.
Ron

Sprint S6 edge update nightmare

I have an Sprint S6 edge with a fun issue. It belongs to a friend of mine, it was doing an update and he got impatient and shut off the phone. So the phone was either bootlooping or clearing the samsung and sprint screen and then would go to a black screen. I went into recovery and cleared the cache and did a full factory reset. Neither did anything different. I downloaded a stock rom and installed it through Odin and after it restarts it says updating, reaches 32% and then say erasing. Following that it reboots into recovery. I am stuck and this thing is driving me nuts. Any ideas on how to get this thing back to somewhat normal?

Categories

Resources