help needed !!
I have a KFHD7(tate) and had been running CM12.1 for a while with only an occasional update using the nightly builds, I only updated occasionally as the unit would not always turn on at the first attempt and would stick at the CM boot logo, after switching it off and back on the unit would run quite smoothly, however none of the updates seemed to cure the problem.
I noticed that there was a new release 'cm-13.0-20160218-UNOFFICIAL-tate' which I flashed via TWRP along with 'open_gapps-arm-6.0-stock-20160301', these were flashed at the same time.
after a reboot the KFHD7 worked fine with no apparent problems, I then downloaded one of the dark themes,(not sure exact one) and this seemed ok at first, I entered the settings screen and only a few words and graphics were visible!
I rebooted back into TWRP recovery and performed a factory reset from within TWRP ... big mistake, now the unit only boots to the blue TWRP boot screen and blinks off after a few seconds it is stuck in a loop and I dont know how to recover it, I have tried the usual combinations of holding the power and vol buttons but still comes on the same .. any suggestions would be appreciated (dumbed down solutions please as not that techy, but can muddle through if step by step instructions)
Hello,
Welcome to XDA.
Try posting your issue in the thread linked below that you got your ROM from.
http://forum.xda-developers.com/kindle-fire-hd/7-development/rom-marshmallow-t3315075
The experts there may be able to help. Good luck.
Related
Hi,
I will prefix this (as there are a few people around with this problem who can get into recovery mode) with the fact that holding down Vol- on boot is not getting me to the recovery / bootloader screen.
I have a rooted HTC Desire S (rooted it nearly a year ago, so info about the hboot etc is a distant memory).
Anyhoo, I decided to have a play about with one of the ICS roms but it was a bit buggy and the camera drivers still aren't working for video so I decided to go back to Endymion V3.4 - http://forum.xda-developers.com/showthread.php?t=1310845
I did a full wipe, installed base rom, installed optional addons and then upgraded to 3.4 - booted fine into the OS so set about getting my system set up the way I like it.
I noticed that endy came with a theme installer so clicked on one of them to have a look, it asked for root, said it was installed and would need to reboot to take effect...
SO
the problem is, it now won't boot and is stuck on the white HTC boot screen.
Holding vol+/- and power buttons reset it but it just ends up back hanging on the boot screen.
Have tried pulling battery and trying again.
Holding Volume Down when powering up is no longer doing anything
So, I either need a saviour to point me in the direction of a fix.. or a kindly sould to break it to me gently when they tell me my phone has gone to the USB Dock in the sky..
Any help will be greatly appreciated.
Thanks
update:
After pulling battery again, pulling out sim and sd cards, booting with vol- held down, i got into recovery. Am going to try and flash a different rom after doing a full wipe, I'll update once it's done but any insights in the meanwhile will still be appreciated
Sorted, cleared the thing out, stuck reaper CM rom on it, rebooted and everything is peachy for now.
Thanks me
Curious if anyone knows why this might have happened?
because you didnt flash the addon zip which was released alongside endymon and then tried to use the addons,it does say on the screen do not use these unless you have installed the addons
Ok, so I gave my wife my old TF101 when I got the 701. I reflashed it with a fresh install of timduru's KatKiss ROM. It's been running reasonably well aside from random reboots. all of a sudden, yesterday it stopped booting up at all. It shows the normal Asus flash screen, but then when it shows the OS specific one (in this case, the weird little picture of timduru's meerkat thing...) it's just flashing random little bits of tha tpitcure all over different parts of the screen an some sort of random flickering and never going past it. I can still boot to the recovery normally, so I wiped it and tried reflashing the same ROM and ended up with the same thing. Tonight I plan to try to download the newer version of the ROM and try, but I fear I may be SOL. Any other suggestions?
Have you tried wiping everything 100% in TWRP Recovery?
Including Data etc ?
*Detection* said:
Have you tried wiping everything 100% in TWRP Recovery?
Including Data etc ?
Click to expand...
Click to collapse
Yes, I did that. Still no good. I'm pretty much screwed, aren't I?
If your TF serial number starts B6O or lower, some B7Os too, then it is SBK1, which means you can use NVFLASHable ROMs - they delete and remake every partition on the TF and reinstall stock ROM - you could try that in case the sdcard is corrupt
stuck at TWRP screen, failed to flash bootloader
Hello everyone,
Not to thread jack but I have a similar problem and instead of opening a new thread I decided to revive this one.
I have a similar problem that my TF101 has been working flawlessly for many years. It is rooted and was running 4.3 ROM. As of yesterday, it just won't boot at all. It has been stuck at the NVidia screen and just sits there. I tried to enter recovery mode by using volume(-) + power and the unit presents the TWRP logo and just loops as well by showing the TWRP screen (3 seconds) then going blank for a second then showing TWRP screen again in a cycle. I downloaded and tried Easyflasher and Brks toolkit and nothing can complete the flash. I can enter MTP mode which the computer can see the device but the manufacturer name and model are not-recognized. I can also enter APX mode but while trying to flash anything I get an error message (error, cannot flash bootloader) and the computer dings (device disconnects).
I have been trying for a day now and have run out of ideas.
Has the unit finally bit the dust? Does any one out there have any more ideas or suggestions on what to try next?
TIA for any help provided.
Hi there everyone, recently signed up on here as xda seems to be the holy grail when it comes to all thing smartphone.
I'm fairly new to these type of phones and recently was given an infuse 4g that was suffering a power button problem.
The power button problem has been resolved with a new one and the phone was working fine for 3 / 4 weeks.
One day the phone shut down by itself and entered the boot loop syndrome. Factory clearing it hasnt seemed to do anything to resolve the problem as it continued to reboot continuosly.
I came across the thread about gtg ultimate unbrick guide in the developers forum and this seemed like a good way to go, get the phone all the way back to stock and then work from there.
Kies installed and all drivers installed fine. downloaded the gtg unbrick pack and followed the instructions line for line. Odin reports everything passed, took about 2:59 to complete.
phone rebooted and continued to do boot loop so went into recovery as stated and wiped data and cache and rebooted again.
phone is still stuck in some sort of boot loop, but it gets to display the 1st of the setup android phone screens, then just as you get a chance to select next to go onto the next screen, the phone reboots.
Any one have any idea what could be going wrong or as im fairly new to this, is there anything im doing or not doing right that is causing this.
The phone is an at&t infuse.
regards
Trevor
sound like an issue with stuck power button. it's a know issue with this model. google "infuse 4g boot loop" there's few youtube videos you can try.
tt33333 said:
sound like an issue with stuck power button. it's a know issue with this model. google "infuse 4g boot loop" there's few youtube videos you can try.
Click to expand...
Click to collapse
I've already replaced the power button with a new one, but the technician i use did say he will remove the power button completely to see if it does the same, just to rule that out
Trev
just redone the gtg flash and it boots into the os (ver2.2.1) and then within about 5 seconds turns off and reboots
can the new on off switch be faulty......im not so sure as in recovery mode, i can leave it on that screen forever and it doesnt attempt to reboot
Tried the one click repair with hemdial or what its called, updating thisnpost via a moto defy mini so excuse any typos.. The hemdiaOl just seemed to meas it up further. So got baxk into downliad mode with odin and reflashed to gtg brick recovery. Not fixed, still booting but at least the screen is now viewable.
To recover one of these phones, is there like a definitive guide as to what to do to first prepare one of these phones for recovery, ie, first, flash to this with cwm and then clear data, cache, dalcik etc. like an idiots fuide, i feel i may need one
Regards
Trev
I've had some previous experience with custom roms on my old Nexus 6P and thought I would try the same for my mate 9. Unfortunately I've discovered the Mate 9 is not as easy to install custom roms as I thought.
I've tried several things throughout the day and I feel I've accidently overwritten things I shouldn't have but can't remember everything I've done.
It is an Optus branded phone so I believe at the start of the day I had some version of L09C34. I currently have an unlocked boot loader and TWRP installed and would like to flash back to the stock firmware, but seem to be unable to do so. The boot loader is unlocked and when I try flashing extracted parts from fastboot, the phone will reboot, reboot again and sit at erecovery. Unfortunately while I can connect to wifi, no packages are found for recovery.
Additionally I now get this lovely colourful screen in lieu of the logo on initial boot.
Any help would be appreciated.
Okay, so I've managed to unbrick it and install a version of L09C432 and get it working again - thank you to various threads on XDA. I think what I noticed was that someone else had tried the C432 firmware on a C33 model and it worked. Without being able to get hold of the C34 firmware, I tried to flash nougat originally and it worked.
This morning, I've noticed I still have an issue where the touchscreen won't work when the phone is cold (i.e I can't click anything and can't turn alarms off). If I reboot the phone to recovery it's fine, so it leads me to believe its an OS thing. Also, if I give it a few minutes in my pocket, or holding my palm on the screen it then responds. This is the issue I tried to resolve by resetting and trying a different rom but seems I haven't been successful.
Finally, when I first turn the phone on and the screen lights up I see a green background with one blue and one red box. Any ideas what I have messed up there and how to fix it? I'm not too concerned, but it would be a nicety.
Just providing updates in case anyone comes a long with similar issues.
I have now fixed the strange coloured screen on initial power on. I've found the oeminfo for the C432 firmware on another XDA thread and took a backup of what was currently there, restored the C432 version and rebooted. I was presented with the eRecovery and no TWRP. Quick check in fastboot mode showed the phone relocked. I unlocked it again and it booted no issues, however was unsure if the custom rom was still installed as I was presented with the option of an OTA update. Initially my sim card was not recognised, so I had to remove and reinstall it but so far so good.
I've just reflashed my custom rom and will see how I go.
The only potential issue I have outstanding is my touchscreen not working either first thing in the morning, or when the phone is cold - i.e I've gone to the gym and left it sitting in the locker for 2 hours and I can't use the touchscreen when I come back. I can unlock it fine with the finger print reader and the phsyical buttons respond but touches on the screen won't. If the phone is left alone for a few minutes the screen shuts off and turns back on approx every 5 seconds until it becomes responsive. Has anyone seen anything like this before? My googling hasn't lead me to anything helpful.
----FIXED----- dunno how to delete posts
---- did specific combination of keys = power+vol_up till the screen turns black, power+vol_down after that, and all keys together till recovery mode boots up. Took me quite a bit of tries, reseted to stock and went on with flashing again from there ----
Hello all,
So I'll start off from the beginning. I was updating my 3.6 Havoc custom OS to the latest 4.2 Havoc custom OS. I started off with making a backup, went on with the data reset, booted into TWRP and flashed the v4.2 img on slot B. And then I booted into the system instead of rebooting into recovery, without Magisk flashed. I feel like not having Magisk flashed is the real culprit here. Please enlighten me on this topic if I'm wrong.
So the problem is that I'm stuck in an endless "bootloader in unlocked", tried out the combinations of pressing P+V_UP and P+V_DOWN, tried out pressing all 3 (P, V_UP, V_DOWN) buttons at the same time, also ADB and fast boot are not detecting the device, so I have no way of entering TWRP again. Please please please help me in fixing this
I have read many articles trying to find a solution to my problem, and none seem to be an closely related to my problem, please guide me to the thread if it already exists. Im on a Mac OSX so MSMtool won't be any help of me.. I would really really apreciate an urgent reply.
Thanks in advance.