I need help bad I'm getting the kernel not seandroid enforcing error when i try to flash stock firmware using odin i get a fail and it goes to firmware issue use recovery in kies and try again it has knox and write protection enabled but i can still flash cmw and go back to the galaxy s4 screen with the kernel error message plz help I'm on facebook Brian Kieffer Monte Vista Co
I have installed unikernel on my g925t s6 edge regular edge.*
Now i need to revert to stock kernel but i can't. If i do a fresh install of the lateset build OI1 from odin the flash procedure complete succesfuly but the phone after that wont boot because it stuck at Samsung logo powered by android. And when i go to download mode Recovery mode is Samsung official and System status is custom. I tried to factory reset with recovery but nothing. I have also tried to fully wipe the phone with twrp but nothing. After i flash the official lastest build with odin the system status is still custom and the phone is stuck at Samsung logo. I have to flash this kernel again in order to boot the phone. But i need that phone works with stock kernel and stock system. I also did an efs folder wipe, which means i have flashed another efs with odin and after that imei said unknown. Than i have repair imei and have my phone back to function. But i cannot revert to stock
Any ideas ?
Wrong thread. You have to go to the GALAXY S6 EDGE Q&A, HELP & TROUBLESHOOTING section..
Posted with my SM-G925f with Crash Power and Tapatalk
Good Day Everyone. My Samsung Note 10.1 started the other day with a bootloop. I couldn't enter recovery so I downloaded odin and a stock Rom from sammobile for the device. I did the reflash it says pass and still was in the bootloop without access too the recovery. I did the reflash in odin with NAND Erase All ticked and instead of using PDA to select Rom I used CSC. It flashed and booted and showed the samsung Logo and stayed there for about 30 min. After a while it showed the recovery mode menu with the driod laying down with a red traingle and exlimation mark. I can't seam to get the Tablet back up and running and really need help and advice. Please can someone help me because the device doesn't work with Kies and that is why I tried Odin v3.10.7. Any suggestions would be appreciated
NAND Erase All ticked
.
Never ever do that .
Well you now need a service centre repair .
@silent001
do you fixed your problem?
I flash the stock rom ,it says I need to install DRK first .It says custom binary (recovery) locked by FRP when I flash TWRP .It's a endless loop. What can I do ?How can I solve it ? I'm going crazy . My phone is S7 GM-930L.
Hi,
I had flash an official 7.0 rom for my Samsung S6 ( SM-920F) with odin.
All is done, but when my phone restart (reboot?) i Had a blue screen " NO command"
and few seconds later recovery mode...
( i cannot join a pic)
this is the error message : NO SUPPORT SINGLE SKU
SUPPORTED API : 3
DM VERITY ERROR . . .
How can i fix it ?
I've try wipe data/ factory then reboot but same result.
Need help
Thank you
sorry for my awful english
Try flashing custom recovery before booting
Hi patrixx,
What is "flashing custom recovery" it's like TWRP ?
i have to be rooted ?
Thank you for your help
Vitamines said:
Hi patrixx,
What is "flashing custom recovery" it's like TWRP ?
i have to be rooted ?
Thank you for your help
Click to expand...
Click to collapse
Yes, TWRP. But it will trip knox counter and void your warranty.
i flash twrp
then when i reboot,
samsung logo then samsung logo , then samsung logo. bootloops
Vitamines said:
i flash twrp
then when i reboot,
samsung logo then samsung logo , then samsung logo. bootloops
Click to expand...
Click to collapse
Flash this zip via TWRP;
http://download.chainfire.eu/1220/SuperSU/SR5-SuperSU-v2.82-SR5-20171001224502.zip
Hi,
i flashed it via twrp like recommended.
Installation since 30min..
are you sure this file is ok with my Samsung S6 SM-G920F
up