I installed CM 10.1 successfully. However whenever I press the power button the display does not wake up. However the screen does not turn on. I have to restart the phone for the screen to turn on. The buttons however do glow.
Anyone else have this problem and were able to fix it?
Thank You,
Karthik
Related
VZW TP with Mighty ROM 6.
Hey guys, I started experiencing this weird problem yesterday. Basically, when the phone is turned on from sleep mode, whether I pushed the button to turn it back on, I get a phone call or text message, whatever...it doesn't show an image on the screen. I can see the screen itself light up (backlight or whatnot), but nothing else. Just a blank, black screen. It happens randomly. I've found that if I hold down the enter key on the d-pad, and turn the phone on, it works fine again.
Any clues, suggestions, advice?
metaGlass said:
VZW TP with Mighty ROM 6.
Hey guys, I started experiencing this weird problem yesterday. Basically, when the phone is turned on from sleep mode, whether I pushed the button to turn it back on, I get a phone call or text message, whatever...it doesn't show an image on the screen. I can see the screen itself light up (backlight or whatnot), but nothing else. Just a blank, black screen. It happens randomly. I've found that if I hold down the enter key on the d-pad, and turn the phone on, it works fine again.
Any clues, suggestions, advice?
Click to expand...
Click to collapse
You may want to try a program such as S2U2 and see if your phone will wake correctly.
Hello everybody,
I have an annoying problem, I am running seans jelly bean 4.0t Rom with the latest update. My issue is when I press my power button once from an off screen state, the screen turns on, shows the power down menu, and then the screen goes black and I get the phone vibrating at every two second intervals. I can do a hard reboot from this point by holding the power button down for ten seconds and the phone will reboot. I have worked around this issue by using the wake screen with volume button feature, but I would like to be able to use my power button again. It does this problem everytime I press it once, it even does it after a clean flash with wiping everything 3x. Has anyone run into this issue before? I have searched for a problem like this, but haven't found any like this. Any help would be greatly appreciated! Thanks in advanced
when the screen times out, or I turn it off, it wont get back up. The backlight lights up and the buttons too, but i have to reboot the phone. I tried it on another ROM (paranoid android) and the problem still occurs.
Anybody help me?
Hello everyone,
I bought a LCD replacement for my OPO, and asked a friend to replace the screen (he had his own OPO, and changed the screen on it a couple times, so I trusted him).
The frame was not included, so the phone is without it unfortunately.
But I have this problem with the screen itself...
I boot the phone, everything goes well, it boots, everything ok, I can do everything...
Then the phone goes to sleep after the 30s, and sometimes when I press the button to turn it on, the lights in the bottom light up, I can hear sounds, I can swipe to answer calls for example, but the screen stays all black.
If I press the power button to turn it to sleep mode and then click again to wake it within 1 or 2 seconds, it works everythime.
Its just when it goes to sleep... And then I have to press the power button to reset the phone, and it boots again.
I'm using the LineageOS Rom, and I never had problems like this before replacing the LCD.
What caused this? Could the screen be "broken" when I bought it?
Thank you for reading this and for the help!
nunong21 said:
Hello everyone,
I bought a LCD replacement for my OPO, and asked a friend to replace the screen (he had his own OPO, and changed the screen on it a couple times, so I trusted him).
The frame was not included, so the phone is without it unfortunately.
But I have this problem with the screen itself...
I boot the phone, everything goes well, it boots, everything ok, I can do everything...
Then the phone goes to sleep after the 30s, and sometimes when I press the button to turn it on, the lights in the bottom light up, I can hear sounds, I can swipe to answer calls for example, but the screen stays all black.
If I press the power button to turn it to sleep mode and then click again to wake it within 1 or 2 seconds, it works everythime.
Its just when it goes to sleep... And then I have to press the power button to reset the phone, and it boots again.
I'm using the LineageOS Rom, and I never had problems like this before replacing the LCD.
What caused this? Could the screen be "broken" when I bought it?
Thank you for reading this and for the help!
Click to expand...
Click to collapse
Well,clearly the issue is lcd itself.Happened with me on my last screen replacement,it was defective.Though in my case,I had to power on/off the device to get the display back.Get a refund or replacement,there's no other alternative.
Hello, I have just rooted my phone, I'm using oos 11, and when I start the phone, it's a black screen and if I hold the power button it shows the shutdown menu normally. Sometimes I can get out by holding the power button. The other thing is that sound doesn't work, no matter what, I haven't found a fix to this yet and wifi isn't working, I turn it on and it doesn't do anything, and data feels slower. I'm wondering if anyone has the same issue(s) as me, and if so, is there a fix?