Hi, I used to think i was pretty smart when it came to technology but this stuff is a little different. I sell cell phones as a "living" if that's what you call it and I tell people don't root unless you know what you are doing. Well seems as though I ****ed up. I have the 1.5 hboot. I successfully rooted with the S-on. I saw on here about the flash image gui thing and decided to try it out instead of using the sdk manager that I had been using. The first thing that I flashed was the clockwork recovery. I downloaded it and put it on my sd card then went into the gui app and followed the directions. So far so good as of then. I then went and researched a little bit and found a kernel I liked and downloaded it and put it on my sd card then went into the gui program and flashed the kernel on. I should have done the Rom and Kernel at the same time but didn't realize that til it was too late. I downloaded (CDMA-AOSP-AnthraX-2.6.38.6-REV_005.zip) kernel btw. Everything went very well and flashed the kernel on and ran fine. I then found a rom that said was compatible and that I liked (infectedrom-eternity-evo3d-35-r117-signed-122611_174844) and used the gui also. It went through everything fine and then asked if I wanted to reboot. I said no because I know that I have to go back into recovery and finish it there. I went and powered down then held the vol down + power button. This is where I Have my problem. When it came on it went and read the sd card and the quick time that it stays on the screen it mentioned about missing PG86 and like 10 lines of things like PG86diag missing etc. My thought is to get a sd card reader and check out what exactly i have on the sd card and possible just add the PG86 info on it. But I am lost and without a phone that works. Some help would be great. I apologize for it being long but wanted to give all the details
Mark
I am not sure what happened but I went and downloaded the stock boot and went into the android sdk and got it to work. flashed everything in recovery mode but now it just sits at the beats audio screen
Related
Thank you for your great board and programs.
Noobie(3 wks), Droid X, 2.3.34
Current issues(just the facts m'aam)
1.TiBU Pro reported as installed. Shows in App mgr. No icon If uninstalled by phone or marked then reinstalled, same issue
2. Cannot format boot sector(partition?) Error Boot Formating (does it thru Rom Mgr, Clwks, and using GLD's total wipe procedure.
3. Can Ti BU Pro be run off the SD card, so that I would not have to go thru market to pick it up before doing anything else?, ie skip whole VRZ thing.
History
I have been having a lot of fun with Roms and themes. Installed Darkslide, couldn't get it working, next Rubix, worked ok, but never could get themes working over it, so I decided to SBF back to stock to clean out whatever was left over. Got back to working fine stock. Decided to try Liberty. Worked well as Rom but I liked Rubix Foc 2.0 better. Picked up Rom Man at this point(had been working thru bootstraper x rooted with command line procedure) Also, forgot, when I rooted 2nd time after SBF, I tried Do root a couple of times. Didn't feel comfortable with that "keep doing it til it works" mentality, so switched to Z4 Root . Worked flawlessly. Put Rubix back on phone but Liberty splas comes up before the rotating cube which does come up.
Thanks for your help Haven't found any of these issues addressed in any of the Droid forums, but Droid stuff is REALLY scattered, so if you could point me in the right direction if it is old hat I would appreciate it.
Steve
I said I would flash cyanogenmod on a friends G1 because he was fed up with 1.6. I've flashed many custom ROM's on several different devices before but I've made a mess of things with this G1 and I can hardly hand back an unusable phone so I would really appreciate your help.
I rooted the phone using Androot, backed up the apps and settings using titanium backup and then the texts using a text backup app. I then downloaded Rom manager and flashed the latest clockworkmod recovery. Next I downloaded the latest official cyanogenmod rom for the dream/g1 and placed it on the phones SD card using my computer. I then re-opened rom manager and used it to select the zip file from the sd (to flash it) on prompt I checked two boxes one to wipe data and one to wipe the dalvik cache and pressed ok.
The phone rebooted into the recovery wiped the stuff, supposedly flashed the rom and rebooted. However it got stuck on the t-mobile g1 boot screen(it never showed anything else first or anything after) I left it for ages with no joy. I then tried wiping from the recovery and flashing again - same thing so i put cm5 on and tried flashing that. Same problem. Then i realised that it probably would not work because I would need to use DangerSPL as the /system partition is too small on the dream/g1. To be honest at this point I can't be bothered with to do that and this guy will be happy with anything above 1.6 to be honest so I thought I would try and flash CM4 because that's based on Eclair I believe (and so it not require I use DangerSPL or any other method to repartition the NAND). However, I tried it twice and still no luck.
At this point I'm somewhat panicking as I cannot seem to make the phone boot and it isn't even mine! Is anyone able to help?
Anyone? Please?
Look, at this stage I will forget custom roms etc. If anyone can tell me the easiest way to get this phone booting android again i would be very grateful.
Even if you could just tell me exactly how to restore it to stock 1.6 from here?
I have flashed roms on phones before - never had a problem but this is driving me crazy - please help!
wollac11 said:
Hi I said I would flash cyanogenmod on a friends G1 coz he was pissed off with 1.6 but im having trouble and I can hardly hand back an unusable phone so i really need your help.
I rooted the phone using Androot, backed up the apps and settings using titanium backup and then the texts using a text backup app. I then downloaded Rom manager and flashed the latest clockworkmod recovery. Next I downloaded the latest official cyanogenmod rom for the dream/g1 and placed it on the phones SD card using my computer. I then re-opened rom manager and used it to select the zip file from the sd (to flash it) on prompt I checked two boxes one to wipe data and one to wipe the dalvik cache and pressed ok.
The phone rebooted into the recovery wiped the stuff, supposedly flashed the rom and rebooted. However it got stuck on the t-mobile g1 boot screen(it never showed anything else first or anything after) I left it for ages with no joy. I then tried wiping from the recovery and flashing again - same thing so i put cm5 on and tried flashing that. Same problem. Then i realised that it probably would not work coz i would need to use DangerSPL coz the /system partition is too small on the dream/g1. Tbh i'm tired so I cba to do that and this guy is not that technical so he will be happy with anything above 1.6 so I thought I do CM4 coz thats 2.0 or 2.1 i seem to remember (and it not require I use DangerSPL) - tried it twice and still not luck.
HOW THE HELL CAN A GET THIS STUPID THING TO WORK AGAIN!??
MAJOR PANIC AS THIS IS NOT MY PHONE - PLEASE HELP!!!
Click to expand...
Click to collapse
Try this thread: http://forum.xda-developers.com/showthread.php?t=803482. I hope it helps.
It's been way too long since I rooted mine to be of any real help but I shall try nonetheless.
Firstly, there is a guide in the G1 forum to unroot and get back to stock firmware: Here (but note that I've never done this).
I must stress though (admittedly from memory) that if you have flashed an SPL or radio image at all, be VERY careful about the order in which you revert back to stock (or go to get a custom ROM depending on which way you decide to go). The G1 is very picky, and flashing things (mostly SPL and radio IIRC) in the wrong order will brick the device. That said, if you follow the instructions you find to the letter you should be OK. But yeah, read twice, flash once.
There is a lot of information in the stickies in the G1 forum. It could take a while to wade through but it should all be there. Failing that, post in the Q&A or General G1 subforums and I'm sure a current user will help you out.
I apologise if I've just posted a bunch of stuff you already know/have read - like I said, I've not used the phone in a while - just trying to offer what I can.
Thanks
No worries now guys i've done it! It was quite complicated but its all sorted now. If anyone is trying this and has the same (or similar) issue then pm me and I will tell you how I sorted it.
Otherwise thanks guys and you can conciser this thread:
---------------------closed--------------------------
Phones been running fine. Have had it for a few months. It's been unlocked and had ROM mngr on it, but never installed any roms to it.
This past saturday while in NY, it was setting on a coffee table for most of the day. I picked it up from the table that night to head out to dinner, it was overly hot. the table is no where near sun or heat. i powered down the phone because the heat made it difficult to use. when i powered it back up, it didn't want to boot. I got the Google loading screen with the padlock, thats it. about 20 min later, it finally booted up and has run fine since then.
Until today. It didn't get hot, but it started running so slow, i couldn't do anything.
longer story short, it will not mount the sd card in recovery mode. I've tried taking this back to stock incase i had to take it into the sprint store. But when rebooting from the recovery mode, it won't always boot. i may have to pull the battery out upwards of 20 times and pwr it back on before it actually boots up and logs into the phone for use.
i was finally able to get the phone relocked. it has the stock rom on it, as it always had. but now i cannot get the stock radio because it refuses to mount the sd card. so in my apps drawer, there is the super user icon. i do not remember this coming with super user at all when i got it.
if the sd card fails to mount (can't even format it from the recovery menu due to not mounting) how can i flash the stock radio back so i can get this replaced?
im still trying to figure out what caused it to get so hot. again, nothing other then the stock rom was ever put on it. so there was no over clocking.
i can't afford a new phone, so i need to make sure that sprint store will swap this out with a new one and not give me the run around.
You should try flashing a kernel 1st
I had the same problem.
Even my screen would get: incredibly hot I flashed a kernel and was good to go
Sent from my Nexus S 4G using XDA App
will that work with the sd card not mounting?
and i've searched here and google, all stock kernels are no longer available for download.
kernel sir flash a new one...and also try to flash a custom rom unlock the phone again and flash the CW using fastboot then from there flash a new rom
Hi all...i just recentlypurchased a g tablet that had cm7 on it already...I downloaded the honeycomb rom and installed it..updated all my apps etc..had it working perfect...then i tried to format my sd card to clear it and make more room....but something went wrong and not sure what, but now I get to the Android screen and then the tablet boot loops....my cwm version is 5.2.11 bekit...so i formatted system, formatted data, and then reinstalled the rom zip file, but i am still getting the boot loop....not sure what to do here, i have never had a tablet til yesterday, and i already geeked to the point it wont come out of bootloader...can someone help me please?..Not sure what to try next...like i said ..never had one before and learning this stuff all over again...i have a rooted sensation so I am fairly familiar with the terminology etc....Thanks In Advance..." Hook a geek up"......lol...Dirtylarry
update
sorry...i could not edit my post from work, so what i tried was to reflash the rom, but when i chose choose rom from sdcard it says no files found also. I formatted the sd card on another computer, replaced the rom on it again, and put back in tablet, rebooted it into cwm, tried again, and still no luck...it doesnt see the sd card...omg...now what?
Update
I got it!!!....a bit different than doing this on my phone...not too much, but a few things are different....i followed the guide in the development section....100% success.....woot....Happy geek dance "
I'm nre to all thiis
I got an HTC Inspire 4 G that i bought on eBay.
I got it unlocked
I'm not living in the US
I rooted it a day ago
Now I'm trying to put on a rom it has been unsuccessful
I've downloaded about three diff ones, none work. One actually booted up, when i went in about phone showed be 4.1 but the look of the phone looked nothing like what was in the ROM description.
I tried even getting an update from ATT which it actually now saying (after I rooted it that I do have an update), but the download stopped so it's corrupted.
So I am stuck. I just need a simple brief instruction on how I get a rom loaded oh I'm using clockworld rom.
Also when I got the other Rom loaded it didn't give me any wifi or data access.
And one the phone didn't even boot up fully it kept rebooting till putting me back to clockworld boot which (good thing I did) was able to recover from a backup I have on the SD.
thanks in advance guys
G
Here you go.
http://forum.xda-developers.com/showthread.php?p=30007255
Sent from a dream.