Hello,
I rooted my phone :HTC magic(Vodafone) from 1.6 to 1.5 (successfully, I used it for 2 days)
I wanted to resore it to 1.6
When I tried to update it using HTC-Radio update "ota-radio-2_22_19_26I.zip" from HTC Website.
I could installed it,however when I restarted the phone it is stuck on Vodafone Splash screen.... Itried following things :
1) I created the goldcard again and tried to reboot it in to fastboot mode ,but phone is not entering in to boot screen and again Vodafone Splash screen appers.
2)I tried with Power+Trackball combination as well,but it only thing happening is :Blue LED glows and screen is completely blank.
3)I tried to detect the phone from my pc using adb devices , fastboot devices commands, but phone is not detected
Can anybody help me out of this?
Is my HTC Magic Bicked/Brocken?
if yes then , can somebody tell me where can I repair it in USA ( I am in Dulles/Sterling VA , USA)
PPPLLLLLLLSSSSSS Help me.....
Welcome to forums
Try reading Wiki here
Also enter to Sapphire section, perhaps you can solve your probs there before thinking on send to repair.
Good luck,
Hi Orb,
Thanks for the reply...appriciate it...
I seen the wiki , but I can not see the possibility to boot the phone in fastboot or recovery mode
Related
Hi there,
I bought a Qtek S200 and I tried to do a ROM upgrade. I followed the instructions given in the website http://kimpeacocke.blogspot.com/2006/06/how-to-perform-rom-upgrade-on-your-i.html
I got the upgrade from this site at ftp://xda:[email protected]_022021_Dopod_PDAMobizEdition_v101.zip
I followed the procedure given in the website given above. After I upgraded successfully the phone has become locked in the boot loader screen. I have done both soft reset and hard reset. Nothing works. The phone gets locked in the boot loader screen. Need help.
Thanks,
Julian
Try to reflash with Qtek ROM instead...
Why you said that it's locked on the Bootloader screen?
Is it frozen or locked?
Hi Rayan,
I tried flashing with the Qtek ROM. I cannot active sync as it does not connect to the device. So I cannot flash. As soon as I powerup, I get the Qtek screen and then it goes to the bootloader screen and stays there. Nothing else happens. I have sent the device back to the guy from whom I bought it.
I got the same problem as Julian - I tried to upgrade with the mentioned ROM and now my device are stucked at the boot screen :?
Some help here ? I'm in same situation
I have an O2 with Dopod rom, after I instaled some software I must to restart and then my O2 are stucked/frozen on Windows Mobile splash screen
Only if I remove the battery I can stop the pda.
I can't do nothing to make him to start. Some ideea ?
:shock:
Later Edit :
solved with http://forum.xda-developers.com/viewtopic.php?t=49298&sid=35f5c1e9e165997b4634ea0c7700ac76
Same issue here with a O2 Xda Neo with German Rom.
Applied the procedure of the prophet wiki : How to CID unlock and Upgrade your Prophet (SPL 2.09 & 2.15)
After step 6 and a soft rest it is stuck in bootloader and will not do anything else, not even off or hard reset...battey has to be removed in order to shut it off....
Any ideas?
Remind me to find the guy who wrote the wiki page on unlocking CID in Prophet......good job pal......
Aaaaarggghhhh %^*^%*^%*^%*
Problem solved..
Hi everyone,
Good news at last. I sent my Qtek S200 to the guy from whom I bought the phone. He fixed it and now I am a happy man. You can check with him if everything else fails. Email him at E gadget Depot ( [email protected]).
All the best..
i tried to upgrade my QTEK S200 with this RUU_Prophet_2151327_21513121_021921_DOP_ASIA_WWE_Ship-NoVendorID.zip it got to 95% and then it gives me nbf file cannot work with your PDA. Please help.
I have this problem too, i know only one exit from this situation - i have flash my s200 with RUU_215737_2157135_023021_QTEK_s200_RUS ROM, now it work fine.
you find it her
bootloader issue
I have the same problem too, If anybody know method to fix this problem please help us.
I cannot active sync as it does not connect to the device. So I cannot flash. As soon as I powerup, I get the Qtek screen and then it goes to the bootloader screen and stays there.
THX in advance for you help
Robert
have same prob but solved thanx to this post
http://forum.xda-developers.com/viewtopic.php?t=58892&highlight=boot
and remember First off all, to enter in Boot Loader Mode is:
Press Camara + Soft Reset, then release soft reset and keep pressing camara button till appear the Boot Loader.
Then upgrade using a ROM
Please, the links to the solution does not exists anymore.
I need help!!
Qtek S200 stuck in tri-color screen, all flashing so far still does not make it work..
When doing a hard reset I get format failed.
/Jonas
I have same problem!
Anyone can help?
TJSM said:
I have same problem!
Anyone can help?
Click to expand...
Click to collapse
Go to HMA4's upgrade guide or my thread in my signature...
same problem
i have exactly same problem and i couldnt solve it too.So can someone help us?
Please someone explain completely what should we do.
i can not active sync and waiting on the bootloader screen
bacardilima said:
have same prob but solved thanx to this post
http://forum.xda-developers.com/viewtopic.php?t=58892&highlight=boot
and remember First off all, to enter in Boot Loader Mode is:
Press Camara + Soft Reset, then release soft reset and keep pressing camara button till appear the Boot Loader.
Then upgrade using a ROM
Click to expand...
Click to collapse
daelee,
you can get normal state, follow the bolded attention at above quote.after entering the 3 colour screen connect USB and you can load the original WM5 ROM on your device. after that, upgrade to any wm6 by the rules and active sync.
the link is dead on that message..
i went to the that page and the link for solution is dead.
http://forum.xda-developers.com/showthread.php?t=376561
find out is there anything that can help!
Guys,
I wonder if you can help. I have trawled this and many other forums and found many people that are having problems with their HTC Prophet or variations of the same device.
I have the Orange SPV M600, it was in my pocket and when I took it out to turn it on, it was displaying the bootloader screen after seemingly soft resetting itself. It is displaying the tri-colour bootloader with the following IPL/SPL
- IPL 2.10.0001 - SPL 2.10.0001
I have tried the following things that I have found in the forums:
1. Taking the battery out for 10 minutes ~ Still the same.
2. Hard Reset ~ I get the "Press SEND button to factory restore" message
but nothing happens when I push the call button.
3. Reflashing the ROM ~ I am unable to do this. I only have Vista and
WMDC does not see the phone in bootloader mode.
Is the phone dead? If so how could this have happened?
If anyone could help I would be eternally greatful. Oh and to add another complication the phone is still CID Locked
Thanks in advance
Barry
well if you where is south africa i would of helped you im sure if you have it runing on xp it will work my jamin did the same and all i did was push the camera button and reseted it got into tri colour mode and reflashed it
sorry that i could not help you but like i said if you in SA we could of tried it on my mashine
Any progress ?
did you ever get this sorted out ? Surely all you're gonna need is a PC with XP and active sync....
If I was closer you could have sent the phone to me and I would have had a go at reflashing the rom, but I'm at the other end of the country....
Hello guy here is a solution to flash under vista i have too a orange m600 and it works fine
http://www.modaco.com/RUU-Vista-done-u-t252977.html
help stuck on the bootlader screen?
guyz i have a jamin.. my cousin was flashin it and flashed the wrong software.. if i reset the phone it shows the boat loader screen!! and i cnat do anythin..caz u tell me which slftware to flash..and how to do it?? My freind told me all solution to my problem's will be solved here
hopin i will get my solution
First of all, download the NVID (no vender) AKU2.2 from here. http://rapidshare.com/files/17208693/RUU_Prophet_220734_2207114_024721_NVID.exe
Then, open activesync, select connection settings and UNCHECK the connect through USB option.
Then run the NVID file. It will take a while, and may seem to get stuck at 80% or 95%. Just leave it alone.
When that's done, you can either use it as it is, or load anyother ROM you want.
i have a bit similar problem
can some one plese guide me how to flash it with xp?????
Regards
First get a version of ActiveSync, any will do, but more recent is probably better. Then download the ROM (see above). In ActiveSync>Connection Settings uncheck the Connect through USB option. Then connect the Prophet.
Next Unzip the NVID file, and run RUU_PROPHET... This will flash your Prophet with a very basic ROM. If you then want to upgrade to a different ROM follow these steps: http://forum.xda-developers.com/showthread.php?t=310452
I was flashing today according htc develeper center their howto...but after the radio firmware update I had to reboot my phone and now it just hangs.... so I was wondering if somebody had the same prob and has a solution for my prob.
Fastboot and adb tool aren't working because my phone can't startup and just hangs my os doesn't recognise my phone.
roobroeckk said:
I was flashing today according htc develeper center their howto...but after the radio firmware update I had to reboot my phone and now it just hangs.... so I was wondering if somebody had the same prob and has a solution for my prob.
Fastboot and adb tool aren't working because my phone can't startup and just hangs my os doesn't recognise my phone.
Click to expand...
Click to collapse
please delete or move to q&a
Hello everyone
I need to fix this phone for my friend but i am stuck
This is info about phone:
I've tried so far:
1.Unlocking via HTCDev - i got the Unlock code and the unlock screen on my phone,i selected Yes to unlock but when i restarted it is still locked,i tried that two times.
2.RUU - i tried this RUU RUU_K2_UL_ICS_40_HTC_Europe_1.17.401.5_R_Radio_0.12.40.00.14_2_10.49.40.11L_release_301902_signed but it always stuck on verifying phone data.
3.RUU to RUU.zip - I copied the ROM.zip from win TEMP folder to SD Card,renamed it to PL80IMG.zip but it always come to Rom parsing,then stops and return to HBOOT screen and of course nothing happens.
I also tried many other things but also failed to resolve this problem.
Please help
EDIT:I installed HTCSync and manage to get past "verifying phone data." in RUU and began the process of flashing.
BUT another problem appeared.
This is the process of RUU:
1.Rebooting to Bootloader - OK
2.Then my phone of course again run into bootloop and the result is:
3.Waiting for Bootloader and error 171 USB connection problem..
I think that this phone or haunted or hardware defective...
i have this problem too , but ...
i install TWRP version 2.7 (that version offer in xda for htc one sv) and finally i reach to TWRP , then i install ViperSV_1.5.0 , i have that stuck again , i just wait and watch for 1 or 2 minute and BOOM...!!!
i got it :victory:
my phone is working again and I'm so happy .
thx XDA
thx VIPER
i hope that work for you.
Unfortunately it can not help me because I can not unlock the bootloader.
Hello,
I have a problem with HTC ONE MINI PO58200
The phone was lying long.
When it boots, it displays Bootloader. No recovery option does not work (restarted)
What can I do?
Please help.
Regards.
Same here, tried unlock bootloader thru THCdev, fastboot says successful ,OK, but phone does not get the next screen, for unlocking. Tried 100 times.
I have RUU and ZIP, but when device reboot after 20 seconds RUU crashes. In log file says:
The input file() DOES NOT exist
Any other suggestions here ?
There are so many HTC with such problem, pls guys anyone help ?? Thanks !
same probleme
I have the same probleme.
itries many methode on internet it doesnt works.
i think you need the original firmeware. mine is from Uk. so there is on htcdev.com kernel files but how to upload it on the phone ?