[SOLVED] Entering bootloader not possible - Dash 3G, Snap ROM Development

ok, after following directions on how to flash back to original spl my winxp crashed-blue screen. Haven't seen that in a while and now my maple is stuck.
Even going in the bootloader won't do no more. When i hold the volume down button it's showing directly the 9% progress bar.
Did i brick it for good? Or can i still try the goldcard method?I'd have to buy the software but want to be shure that it will work.
Any advice is very welcome...
UKFencer

First of all: Did you remove the battery? Just remove it, wait a couple of seconds, press and hold volume down and press on/off. Release on/off and then volume key, you should be back to the start of flashing.

AP756 said:
First of all: Did you remove the battery? Just remove it, wait a couple of seconds, press and hold volume down and press on/off. Release on/off and then volume key, you should be back to the start of flashing.
Click to expand...
Click to collapse
Thanxs, tried again and it worked. Was able to flash to the original ROM...didn't press the VOLUME-DOWN and POWER-BUTTON long enough...

i had the same problem now i'm stuck in 9% progress bar...
i really don't know what to do...i tried so many things but no good...
it would be nice if someone helped me..

Hi there,
i just tried the same:
- battery out
- battery in
- volume down
- power down
But the phone starts directly without pressing any key. Directly when i insert the battery it starts to boot.
Windows looks like working but it shows "insert SIM" and reboots. Again and again.
Reaction to the lightsensor is there- but no keys are working...
I think the windows hangs- but until i'm not able to enter the bootloader its not possible to flash the phone...
in other forums is written about press vol UP button here is written about vol DOWN button... What is the correct?
greetz

Related

major problem...

So... I've tried to update my rom and I've done it. Didn't like the ROM and tried to change it.
soooo. I messed everything up. My magic can't boot (it stalls on the boot screen showing "HTC Magic") and most important, I can't enter fastboot to restore a working ROM
Any ideas on this one before I go to HTC Support?
regunus said:
So... I've tried to update my rom and I've done it. Didn't like the ROM and tried to change it.
soooo. I messed everything up. My magic can't boot (it stalls on the boot screen showing "HTC Magic") and most important, I can't enter fastboot to restore a working ROM
Any ideas on this one before I go to HTC Support?
Click to expand...
Click to collapse
can you not get to the mode pressing home and power.
from there you should be able to use adb push to send new update to sd card
magpie2000k said:
can you not get to the mode pressing home and power.
from there you should be able to use adb push to send new update to sd card
Click to expand...
Click to collapse
nope. Every key combined with the power button just boots the device and show the "htc magic" logo. nothing more.
I had the same sort of thing once. I removed the battery and before I put it back, I already pressed the home-key as well. Then it went into fastboot mode after I put it back in. With this way I could sent a new update.zip to the phone, flash it and then it was working again
Hope this helps
Machielh said:
I had the same sort of thing once. I removed the battery and before I put it back, I already pressed the home-key as well. Then it went into fastboot mode after I put it back in. With this way I could sent a new update.zip to the phone, flash it and then it was working again
Hope this helps
Click to expand...
Click to collapse
Well, it's not hard to send the update.zip. I can use a microSD 2 USB and copied it that way.
By the way I think it's the "return" key to enter fastboot. Not "home".
Tried the battery-removal trick. Didn't work.
Take out your battery, hold the volume down button and put the battery back in whilst you're holding the volume down. This in theory should bring you to fastboot. Just keep holding the volume down until you reach the fastboot screen. If after you put the battery in, nothing happens, keep holding the volume down and press the power button...
Should work...
TigerTael said:
Take out your battery, hold the volume down button and put the battery back in whilst you're holding the volume down. This in theory should bring you to fastboot. Just keep holding the volume down until you reach the fastboot screen. If after you put the battery in, nothing happens, keep holding the volume down and press the power button...
Should work...
Click to expand...
Click to collapse
didn't work
One other thing to try is to hold the two left most keys on the front of the phone (these are different depending on your phone brand) whilst holding power, this will take you to a recovery screen where perhaps you can do something from there?
I'm assuming you get to see a splash screen first and then you see the HTC Magic logo...
TigerTael said:
One other thing to try is to hold the two left most keys on the front of the phone (these are different depending on your phone brand) whilst holding power, this will take you to a recovery screen where perhaps you can do something from there?
I'm assuming you get to see a splash screen first and then you see the HTC Magic logo...
Click to expand...
Click to collapse
the 2 most left keys are the "answer" and "home" buttons. tried it. still getting the logo.
the phone vibrates and shows the logo...
Turn it in for repairs.
regunus said:
the 2 most left keys are the "answer" and "home" buttons. tried it. still getting the logo.
the phone vibrates and shows the logo...
Click to expand...
Click to collapse
Well, I am exlcuding the green call button and the red end button (which you use to run on your phone), but if it's freezing at the logo where it vibrates, then there is a problem.
I had a similar thing, but I was able to boot my phone into fastboot/recovery with the battery trick.
My two left buttons on my device are the home button and the menu button. Try holding this down when you put the battery back in. Unfortunately, the situation doesn't sound too hopeful.
TigerTael said:
Well, I am exlcuding the green call button and the red end button (which you use to run on your phone), but if it's freezing at the logo where it vibrates, then there is a problem.
I had a similar thing, but I was able to boot my phone into fastboot/recovery with the battery trick.
My two left buttons on my device are the home button and the menu button. Try holding this down when you put the battery back in. Unfortunately, the situation doesn't sound too hopeful.
Click to expand...
Click to collapse
did you try powering on while holding only the home button?

How do I hard reset my fuze?

I've been trying this over and over and all I get is the initial bootup screen.
I hold down the Volume Down, Enter (center circle button) and then use the stylus to hold down the Reset button. I hold all 3 down at the same time.
Every time I do this the phone reboots as if I only pressed the reset button using the stylus.
I've tried holding all 3 down for over 5 seconds and I've also tried releasing the reset button first and continuing to hold down the Volume Down and Center/circle button (which is the way described here on xda) and all it does is do what I believe is a soft reset.
Shouldn't I be seeing a screen saying it's going to delete all data?
What am I doing wrong?
EDIT: I should mention, I just finished installing TAEL's new rom ([ROM][WWE][PRO|FUZE][WM6.5.5.5|23518][14JAN10] TAEL ROM v3.23518 • SENSE EDITION • ), which is a windows mobile 6.5 rom, but every time I try the hard reset it's showing windows mobile 6.1. Although it does show TAEL rom at the initial screen where it also shows the wrong windows mobile version.
hard reset fuze
You must keep holding the volume up and the circle button pressed AFTER you remove the stylus. this should take you to the RGB screen and then instructions on how to continue.
Good luck
Actually, that method didn;t work for me either.. but this one did...
Take out the battery... put the battery back in...
Press and hold the CENTER BUTTON and VOLUME DOWN... While still pressing them press and hold the POWER button. Then you will get a screen saying press volume up to hard reset...
I hope that works for you
That was so easy! Thanks.
Teej53214 said:
Actually, that method didn;t work for me either.. but this one did...
Take out the battery... put the battery back in...
Press and hold the CENTER BUTTON and VOLUME DOWN... While still pressing them press and hold the POWER button. Then you will get a screen saying press volume up to hard reset...
I hope that works for you
Click to expand...
Click to collapse
Xino1 said:
You must keep holding the volume up and the circle button pressed AFTER you remove the stylus. this should take you to the RGB screen and then instructions on how to continue.
Good luck
Click to expand...
Click to collapse
Many people often let go of the buttons before it turns back on.
Note: You can release the reset button but still have to hold Vol Down and Center to get to the Bootloader.

[Solved] Bricked phone

Hey,
i have managed to brick my phone :\
ive flashed the Kingcobra 1.5 on top of 1.4.1
when i rebooted, got my screnn stuck on the "this build is for development...."
cant get the adb to do nothing cuz it says ** daemoon stil not running error **
(the phone is still on, no way to turn it off)
when im pressing the VOL down & power (or just power for 10 sec) alltogether i cant reach the fastboot screen...
i've waited for the battery to fully drain, charged it once again without powering it on, and then using the adb
at the beginning when i tried to erase c
sorry for the misspelled words im kinda nervous :\
anyone can help me? any more info i get give..?
THANKS!
EDIT: attached the status that i have right now on my phone
Just press and hold the power button for 15 seconds or so. It should power off. Then press n hold vol - and power. Only hold the power button for 2-3 seconds, then release it while still holding vol -
18th.abn said:
Just press and hold the power button for 15 seconds or so. It should power off. Then press n hold vol - and power. Only hold the power button for 2-3 seconds, then release it while still holding vol -
Click to expand...
Click to collapse
10x, newbie mistake
u save me from RUU
THANKS ALOT!
No problem....u can add [RESOLVED] to thread title if u like glad it worked out for ya.:beer:

My One S never boots up and keep restarting automatically

My One S has worked fine until now. Now, however, it suddenly started to reboot nonstop. I get the first two starting screens, then it shuts down, and in a few seconds it starts again. The process continues until the battery is dead. I've tried to hold in the shutdown button for various amounts of time and it leads to the process halting, ie the mobile keeps being off. But once I release the button the process continues once again.
Any ideas?
Can you get in to bootloader?
Power down then power + Volume
Mr Troop said:
Can you get in to bootloader?
Power down then power + Volume
Click to expand...
Click to collapse
Dont seem to work. Ive tried multiple times to press both power and volume while the One S is shutdown. Have anyone heard of this problem before?
Are you HTC Dev unlocked?
Rooted?
Hold down Power you will see all 3 keys at bottom flash just keep holding,this should hard reboot
If not reboot device when screen and lights go off hold volume down then factory restore
Mr Troop said:
Are you HTC Dev unlocked?
Rooted?
Hold down Power you will see all 3 keys at bottom flash just keep holding,this should hard reboot
If not reboot device when screen and lights go off hold volume down then factory restore
Click to expand...
Click to collapse
This didn't work on my phone :S I tried hard reboot and factory reset, both doesn't work. :S
What else I can do, I'm so panicked at the moment, please help me.
I can't get to the menu screen, it just keeps reloading between htc one s and htc logo please help.
I was having this issue the other day. It took me a while to get it figured out and this thread helped me: http://forum.xda-developers.com/showthread.php?t=1630459
To get into bootloader was hit and miss for me. I found that the best and most consistent way was to hold down the power + down volume, let go of the power while holding down the down volume after 5 sec and then press the power again then let go of both buttons.

(Fixed) HELP!!!! My HOXL' rom is stuck

Hi everybody! Im new here and maybe my english is bad (sorry for that) but i have big problem!
I have HOXL (at&t) with twrp recovery and i flash Cleanrom v preview build BUT i forget to do factory reset before that.Now my phone is stuck on the boot animation and i can't do anything,even i can't connect with usb cable with my computer(led is not lightening)
Can somebody tell me how can i go into the bootloader or anything that can fix this problem?
Just hold the power button until the phone resets. Let off the power button for half a second then press it again and hold it and also hold vol (-) until you get into bootloader. From there select recovery.
Remember, no matter what if your phone is powered on, pressing and holding power WILL reset the phone. Its a hardware feature to simulate a bettery pull.
tnx
18th.abn said:
Just hold the power button until the phone resets. Let off the power button for half a second then press it again and hold it and also hold vol (-) until you get into bootloader. From there select recovery.
Remember, no matter what if your phone is powered on, pressing and holding power WILL reset the phone. Its a hardware feature to simulate a bettery pull.
Click to expand...
Click to collapse
Thank you very much man !!! You save me !!!
Thats what we do. Next time u see a guy with the same issue, YOU save him and maybe someday he'll save me. Thats why xda is the best:beer:
Oh it also can benefit others if you modify the thread title to include (Fixed) or similar

Categories

Resources