mda compact iv stuck on algin screen after duttys 3.5 rom upgrade
Related
Hi there, I did a flash of the latest Wizard AKU2 Rom into Charmer (MDA Compact 2) - now the bootloader is destroyed, I can't get into it. The device just flashes (the whole screen and the led) shortly every 2 seconds. Nothing more.
Any chance to repair a bootloader?
Hi fellas, I have a I-mate Jamin (Prophet) G4
While upgrading to RUU_Prophet_220734_22-7114_024721_NVID.exe, I lost ActiveSync synchronisation. This was while it was copying the extended ROM. Now when I did the hard reset, it only shows the Qtek splash screen and doesn't do anything else. Is there any way to rescue the XDA?
Thanks!
hi...
i faced the same problem before
you need to go to bootloaded mode (press camera button and soft reset)
you will get tri colour screen...
Flash again....
it will get stuck at 85% but wait for the 100% completion.
restart...
Hello everyone, unable to hardspl so used the jump spl and tested with the splash screen included there, which is an at &t splash.
I have tried following hte instructions for changing the splash screen and i put it in with a customruu.exe but it didnt seem to change it :S
Flashed dutty's v4 rom, and it still comes up with the AT&T screen then a splash screen with sound...
please help! i want this ugly at T screen off my pda.
Thanks in advance!
Cheers
Alright, i worked out to flash it off to a different one, but it still does the one i changed it to, then the animated one that is included with dutty's rom...
can i have just 1???
cheers
Hi friends.... I've got problem with my Treo 750v. I tried to install non-Treo OS and after that the screen is black. I've tried reinstall to Treo WM6.1 that I used before, installation is complete and success, but after that nothing happened, the screen still black. If I push the side button with reset by stylus, the screen show:
CHEE100
IPL-0.20
CHEE100
SPL-1.40.Olinex
Could someone help me please....???
Hey,
Since i got my tytn ii Back on again, I still want to flash it.
But With hspl It stucks at 0%
With jumpspl It doenst work i get white screen.
With sd card it stucks at loading.
Kinda out of options now, I hope you can help me out and tell me why HSPL just dont work...
I run spl 3.29
Tnx allready
Grtz